UIInosoo RCA Cable With Ground Wire, 10ft Turntable Gold Plated 2RCA Male to 2RCA Male Stereo Interconnect for Turntable, Preamp, Record Player, Amplifier

Nice quality for low price

Works great with no noise introduction that I can detect and as my turntable is on a separate stand this length is what I needed to reach the receiver.

This cable is inexpensive, but works really well. Two RCA jacks with grounding wire. There is not a connector on the ground. You have to supply your own. Which was not a problem. I used my own spade connectors and I also placed shrink tubing over the connectors. The grounding is very important with a turntable and your amplifier. If you do not ground, you'll get a very bad hum through the speakers especially if your speakers are close to the turntable. I highly recommend this cable with ground.

My Turntable is in a place where I cannot have the Phono preamp close by. It was difficult to find a ground cable that was pre-terminated with little spade connectors and this long. I opted to try this instead. Grounding works perfectly fine. The only complaint I have is how narrow gauge the ground wire is. It was difficult to get it to stay when tightening down the screws on my TT and preamp. And you need to make sure that your grounding terminal is close to your RCAs, as there isn't much slack.

Good cables at a great price to hook up my new turntable. Yes, my Angel Horn turntable purchased here on Amazon has Bluetooth but I wanted to go full old-school. There are other vastly more expensive cables available on Amazon but at the end of the day, you are still dealing with decades-old technology with RCA cables. These work just fine.

I'm disappointed with the quality of these phono cables. The ground wire should really have a spade connector as the bare wire makes it more difficult to install. I also have a constant wire hum with these cables. They work, but not well enough.

I bought this because of the price and because of the length. Most of these are only 3 feet, and I needed something a bit longer. The only downside is that the ground wire is very, very thin, making adding a Y connector a bit difficult. It would be great if that was already installed and could be removed by those not wanting it.

Got a turntable to go retro. First I got cheap rca cables at Walmart. The hum was terrible. Looked into cables, watched some videos. Concluded I didn’t need the absurdly expensive gourmet cables, just not the super crappy ones. This cable completely fixed the hum problem. Excellent.