Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(Warm White), Power Adapter not Included

Long lasting and actually sticks.

The Water-resistant IP65 12V lights are perfect for outdoor use. They’re sturdy, easy to install, and handle the elements well. Great for adding lighting to patios or driveways!

bought these to build footwell lights in an older vehicle - the warm white is a fairly close match to the dome light, and they stick on the bottom of the dash panels reasonably well (I keep 3M tape around for these kind of projects, so I wasn't too disappointed with the minor adhesion issues).Like all of the water-resistant strings, these present a challenge to scrape down the sealer when I try to solder wires on the cut lines (every 3 LEDs) so I'm content with using the existing ends for my two lights and then try to use the rest in another project - back row footwells, perhaps?

Easy, very easy to set up and definitely enhances the aesthetics of your home. I purchased the white set. It makes the home look bright, modern and classy.I highly recommend for sure....

I prepped the metal surface on our camper with alcohol, let dry 24 hours. Then I applied 3M VHB double sided tape, let cure 48 hours; also used a roller to smooth out any bubbles. Then we applied the light strip after removing the backing and rolled it with a roller. Good adhesion everywhere but right at the connector end where the wires attach. It is suprisingly bright at night. I imagine that the strip adhesive on its own is not enough to support the strip against gravity.

Made sure 12vdc is greater than 2A, removed remotes battery shipping plastic, directions say "long press 5 sec" button, over and over and over, no workie...PLUS, never says what you do with the TWO extra Red & White cut wires ? Maybe its DOA - I may need to order Hundreds of these POSs until i find a good one= its FREE RETURNS. Maybe after a few thousands wasted kits someone might notice & help.

Not bright

This LED strip was just what I needed to brighten up the area inside and under my camper cabinets. I bought the soft white strip and am very pleased. The light strip is covered with a clear silicon rubber that makes the entire string very flexible, durable, and waterproof. Safe places to cut the strip are marked on the strip, making it easy to cut to length. Any length can be cut, as long as you cut where indicated. I cut three lengths to install in/under my cabinets. I cleaned off the clear silicon rubber covering to expose the solder pads with an exacto knife and easily soldered wires to the strip. The power and ground wires can be soldered to any set of pads anywhere along the string and it will power the entire string. Make sure to make the proper pos and neg connections, as LEDs are sensitive to polarity. Polarity is marked on the strip. The adhesive back sticks very well to a smooth surface. Very low current draw. Perfect for my installation. I have plenty left over and am looking for other places to use it!