NCIH26-3

I sent it back, it had a bend in it, about 0.050” in the middle. The printing on the blade wasn’t very good

Good as described, good to have it at shop

I didn't get the damn Allen wrench it goes with it.

It Works, and that says a LOT. Don't waste your time & money on those cheap Hss-Cobalt blades. Life is so much better with this cut-off tool. I have three sizes now (widths). The NCih 26-2 is .090" wide, works great and doesn't remove excessive amounts of material. All three blades fit the same holder so if you already have the holder as I did, just get this blade. If you haven't bought any yet, buy this one with the holder as it's the most useful. I sharpen the carbide tips (on the face side only, not the top) after installing them. They tend to be a little too dull as received, not a problem. If you buy the 'really expensive' carbide tips, you'll end up sharpening them anyway.

ok