ACDelco GM Original Equipment 214-1680 Vapor Canister Purge Valve

It's fits very just like old on my car, I just had strap it down, due to being to loose and no code worked as other one, very satisfied, just double check ur work after

I started with this part after getting a P0449 code on my 2010 Chevy Silverado. It did not work. It was easy to install and surely works correctly. My truck needed to have the Canister Valve Solenoid replaced. I replaced the Canister Valve Solenoid and the engine light has not come back on. Between this part and the other part, you should be able to fix your vehicle and get rid of the this code. I'm sure I still saved alot of money doing the repair myself even though I may have been incorrect with my initial effort. So, if this part does not work, try the Canister Valve Solenoid too. Good luck.

The ACDelco GM Original Equipment 214-1680 Vapor Canister Purge Valve is a top-quality replacement part that ensures your vehicle runs efficiently and reliably. Designed specifically for GM vehicles, it guarantees a perfect fit and easy installation, saving you time and effort. This purge valve helps to maintain optimal fuel efficiency and reduce harmful emissions, contributing to a greener environment. With ACDelco's reputation for durability and performance, you can trust that this component will last for years.

I replaced this along with the vapor canister and vent valve although the code I had was only for the vent valve. I have this arms so installation took about 10 minutes. This is on the driver's side engine block, just above the crankshaft position sensor. You may want to replace the mounting bracket, part #24577194. There's a black clip on one hose and a white clip on the other. They're tricky but can be removed without breaking them. Do not use tools to force them. The wire connector is simple to remove. This will fit many years of the Trailblazer/Envoy/9-7x/Rainier/Bravada/Ascender. Also, the white clip on the rear of this valve comes with Dorman 800-023.

Worked as intended. Easy to change

Easy self-repair and immediately cleared my EVAP leak diagnostic codes on my 2007 Tahoe.

I bought this to replace a reputable name brand one that was a few bucks cheaper, but only lasted two and a half years. Save yourself the hassle of doing this again in a few years by getting the ACDelco one the first time around. Time will tell, but this is the OEM part so I expect it to last as long as the one that came on the truck. On my 2008 Colorado, the clip holding the line on the front has a tiny black tab that you push SIDEWAYS to make it release. At the intake it has the same type of clip if you want to see how the release works or disconnect the other end. The clip holding the line on the back has push tabs on opposite side that are pushed IN to release, but disconnecting it at the junction point about 6 inches away will free up the part so you can move it into a position that is easier to work with.

Works Great. Much better than the other generic brands. This is the one to get.