High Temperature Gasket Paper, Ceramic Fibre Furnace Gasket Material Insulation Fireplace Sheet for Pellet Stove, Wood Stove, Boiler, Furnaces, Kiln, Forge DIY Exhaust Gasket, 7"x 10"x1/8"Thick, 8 Pcs

Used this to make a seal for an oven light fixture. Could make 3 seal from one sheet. the package had 4 sheets in it. The package was about the same price as one seal. So it was worth buying the package and making my own. Took about 30 seconds to cut it out.

I used this to seal the air adjustment valves for my wood-burning stove. It was easy to cut and shape. It provides a good seal. The gasket material is a little fragile, but if you are careful, it will last. I open and close the air intake controls several times a day and it works pretty good. The package comes with enough to make several replacements if you damage one.

Just what I needed.

Good value and well made. Made custom gaskets for my oven as the parts are no longer available. Seals well and is more durable than the factory part.Easily cut with scissors and easy to use. Has worked fine in a self cleaning oven.Material has worked flawlessly for 3 months surviving daily oven use. Highly recommended!

I used this to balance my stove blower on the wood burning stove. It held up quite well.

It’s paper so it’s not tough. However it’s effective at reducing heat transfer.

High Temperature Gasket Paper, Ceramic Fibre Furnace Gasket Material Insulation Fireplace Sheet for Pellet Stove, Wood Stove, Boiler, Furnaces, Kiln, Forge DIY Exhaust Gasket, 7"x 10"x1/8"Thick, 8 PcsFirst impressions: Nice stack of ceramic fiber sheets. The sheets are thick and ready to use.Installation/setup: Use to line your furnace or use as a gasket on the door. Use a rigidizer to make the fibers less likely to fray and to last longer.Final thoughts: These sheets are made of fibers that can be irritating to the skin, so wear gloves and long sleeves. The fibers are not good for you to breathe in either, so I recommend wearing a respirator and safety glasses or a full face protection one. I plan to use this to reinforce the corners of the raku kiln I am building for my pottery hobby. I like this and I’m glad I got it.⭐️1 star - I don't recommend it at all, poor quality.⭐️⭐️ 2 stars - I don't recommend it, it has multiple faults, or a very high price.⭐️⭐️⭐️ 3 stars - It's passable, It has some faults but the quality is ok for what it is.⭐️⭐️⭐️⭐️ 4 stars - Product quite acceptable, it does what it promises.⭐️⭐️⭐️⭐️⭐️ 5 stars - Product that I totally recommend.

Size was as expected. The material is a little stiff, but could be bent into a 1.5" radius without too much difficulty.I tested a corner of this with a propane torch. I was surprised to see that, although it didn't burn, the properties were definitely changed - after the flame, the material became very crumbly. It didn't fall apart on its own, but could easily be broken up with light pressure from a fingertip. Now, this material is rated to 2000F, and it's possible for a propane torch to run just a little hotter than that, so this could be using it outside of it's spec. Still, I'd be careful if you're using it at these high temperatures and needing it to maintain it's mechanical properties. As a gasket, and at lower temperatures, it should be fine.