6-Pack Aluminum Alloy Bench Dogs with Non-Slip Pads - 3/4-Inch (19mm) Workbench Dog Hole Accessories for Woodworking and MFT Stops Red

I like these as the bench dogs in my bench vise instead of fully sized ones. The low profile and lack of any sharp edge on top makes them less likely to catch my knuckles while working at a woodworking bench.They seem plenty strong to clamp between dogs in the bench. They fit 3/4” holes or slightly smaller as advertised and fit shallow holes fine.Be careful about clamping them too hard especially with show surfaces. They hold up fine, but they will dig into the wood leaving marks or dents. The smooth aluminum surface isn’t good for contact cementing leather or rubber too either. The bond breaks easily.I would get them again for other vises or if I ever make a portable workbench.

They work better than I was expecting. For the money that I paid there's always that lingering doubt that they'll just end up in the bottom of useless tool drawer. Not so. These work great with my 10" Yost front vise. They fit nicely into 3/4" dog holes not too tight and not too loose.

These bench dog stops are decent considering they weren't expensive at all. They fit in my 3/4" holes with no issue . If they were snug, it's simple... drill the holes out a little. Don't expect to get the clamping strength of glue up clamps, but they will hold things steady. I only clamped down a throwaway strip of 3/4" birch plywood and it held without and slippage.

The flat sides are a great bonus, as well as the non-slip tops. Lovely pieces of hardware.

work great on workbench...layed it out...... drilled holes.. and your done Zoro says buy

These are 19 mm and are a little tough to get in my 3/4” holes. They are well made and I plan to keep them. Just make sure you drill 19 mm vs imperial measurement.

Does not fit tight in 3/4 inch hole. Had to coat stem with several layers of polyurethane.

Accurate size given so you knew what size to drill holes on your bench. I use them all the time for holding wood still on my bench whether cutting or sanding they work great ! Definitely recommend.

Fits well and sturdy