PANTHER MARINE 3005.528 KPP100B King Pin Anchor Pole - 2 Piece, 10' - Black

Love this for getting the boat held at the beach. Must have and almost as cheap as making it yourself. The only drawback is the screw together could be smoother, it works fine just not smooth.

Use a few time with my kayak in the Florida Bay. It holds well in the silt mud. The stainless steel fittings do tarnish with rust, but are functional. I just hit it with a wire brush and some WD40 to maintain.

FEDEX DELIVERED THIS IN A TUBE, THAT HAD JUST BROKEN TAPE ON EACH END. I PICKED UP THE TUBE AT MY FRONT DOOR AND THE POLES SLID OUT. NO CAPS, JUST BROKEN TAPE. GUESS IT'LL BE RETURNED THE SAME WAY!! First impressions....same as Others said, the pieces are difficult to thread together. 100% CORRECT. The threads were rough. The minute I tried to put the two pieces together I was already NOT liking this thang! Ii can just imagine being on the boat in the wind fighting to get these two poles attached.....NOT GOOD. Had to remind them I was due a refund. to get a refund, week plus later

Nice sturdy pole. Threads can get a bit wonky. But hold my Jon boat with 2 adults

As described, use in south Louisiana and works as it should

I received my pin 10' way earlier than expected. I was prepared to have issues screwing together as others have but that was not the case, although not real smooth it did go together easily. The weight is pretty good and I am confident it will hold in place. When put together it does have a little bit of flex in it which is expected due to length and material. Overall first impressions are very good I plan to buy atleast 2 more if initial testing holds up. I do recommend.

We used two for about 7-9 foot of water. We positioned two holders on both sides of our outboard motor and was flawless. Easy to use. I have wasted to much time in my life pulling anchors up and probably will never go back after these. I suggest buying two if you're in areas with large wakes and high winds.

This is a two piece pole that needs to slide thru a bracket on the boat to be able to stick it down to hold the boat. Center connection is not inset sufficiently so as to be the same diameter of rod and hangs up on retraction. Rod flexes just above connector and sometimes makes extraction very difficult, especially in the wind or tidal flow. Poorly made. A little bit better engineering needed.

Using it to keep stern in place for island visits up north on the French River and fishing ,works great!

ジョンボートでの使用で爆風対策で購入しました。 別途、専用マウントが必要ですが、非常に使い勝手が良いです。 リグる時や根掛かり外す時などかなり重宝しています。 長さは3.１を購入しましたが、意外と3.７でもよかったかもしれません。 スティックイットと違い分割式ですので保管や運搬の際のスペースは気になりません。 唯一、欠点なのが値段です。 アンカー、マウントで約６万… せめて４万以内であれば買いやすいかと…