Eightwood Aluminum Box Electronic Amplifier Project Enclosure PCB Circuit Board DIY Case, 4.32 x 2.82 x 1.13 inch (LWH)

Very nice enclosures especially to keep RF in or out of your electronics.

Excellent construction.

I used it to mount control boards for PWM fans on a firend's golf cart. Looks like a professional installation but done by an amature.

Needed a box to make a bench harness for PCM programming and this one was the perfect size. Love that it's aluminum because it's easy to machine yet sturdy.

I'm giving this five stars for being conductive and easy to drill through. No need to run shielding wires inside.

Ok, it's an aluminum box. Workmanship is good, but not perfect. The end plates are just 'slightly' larger than the box they screw onto. This could lead to scratches on whatever surface you place it on. A tiny bit of machining is in order, or put a few rubber feet on the box. The screw holes on the end plates are 'almost' perfectly aligned with the channels on the box, but not quite. The screws still fit. Overall I'm pleased with this box.

Very good project box: 1. This box is very sturdy when assembled. 2. It can be opened in a couple of ways - either take the end off or take the top off 3. The end pieces are thick enough to mount switches, jacks, etc.

This enclosure is an excellent solution to house small electronic circuit projects. Good quality extrusion and end plates are easy to work with and present a professional finished appearance. A good value worth every penny!