QWORK Solenoid Relay, 12V 250A Winch Relay Solenoid Replacement Contactor for 3000-5000lbs ATV UT Winch Control

it worked on my harbor freight winch

This solenoid worked great for my habor frieght 2500lbs wireless remote winch. My winch stopped working from the remote. I swapped the solenoid out and it is back to working great again.

Works great.

Twelve volt solenoid for winch works well. The threads between the nuts and the studs are a little rough . When paired with a remote wench controller , the relays seem to have a nice crisp engagement. The plastic casing on the solenoid seems to be of good quality. Some type of thermal set plastic.

Easy to wire up and worked well with no issues. Has the same flipity flopity as another review. Hopefully it last a while. If not, it was cheap enough not to worry really.

This reversing relay has small studs with 10 mm nuts- 6 mm studs I believe. The two internal relays are operated by the each one of the outer spade terminals being either energized or grounded to the center terminal. The solenoid terminals do not appear to require a certain polarity so either positive or negative control is possible. The default seems to be ground control since a pigtail between the center pin to the positive battery stud is included. A wiring diagram is not included but the arrangement of power supply was good for my situation: The positive and negative terminals are alternated to the two motor terminals by energizing one solenoid at a time. If both solenoids are energized simultaneously, the unit will not short out. This is meant for a two wire reversing motor where battery power and ground are only provided to motor through this relay, not three wire motors where the ground is provided directly from motor to battery.

Good quality solenoid. Bigger then a stock can am defenders winch solenoid but I made it work and happy with it.

Good product

Funktioniert

Easy swap out. A few millimeters shorter than my WARN controller. Fits no problem in the previous location. Operates my 3000 lb rated ATV no problem. No instructions but easy to figure out. Connection tips: - The POS and NEG markings are for the battery hookups. - The other 2 unmarked posts are for the winch motor. Wire order does not matter. - The middle flat tab has a wire connected to the NEG post and I kept it there. The other 2 tabs are for your winch switch connectors. If the winch operates in the reverse direction, swap the switch connectors.

Boot winch werkt terug perfect

Onderdeel netjes afgewerkt en snel geleverd, wegens nodige stuck voor bedrijf geweest alles was tip-top in orde. Dank u S.O.S-CAR

Funkar bra