PETECHTOOL 50 Pack RJ45 23AWG Cat6a Cat6 Large Pass Through Connector Gold Plated 8P8C Ethernet Modular Plug UTP Network Ends for Unshielded Twisted Pair Solid Wire & Standard Cables

These are the best to use with Cat6 cables, I tried other ones but the cat6 wires are to fat. These slide through easily. You just have to make sure you have straightened them.

These make it it quite a bit easier to make up a cable than the non push-through sort. The documentation is clear and concise with a nice colour diagram. Hurrah! I used a crimp for AMP connectors but seemed to work fine. Perhaps the intende tool will do a good job cutting off the excess cable.

good but not for awg23 size cable as advertised. good quality though but for smaller diameter cable

Despite them claiming larger diameter I couldn't fit my cat6a cable through the connectors. I tried to just pass a single strand to check and it kept getting stuck. It would of been far easier to have designed them with a removable guide. I can't use any of these connections and unfortunately past the return window as had building works going on. If you want to buy them try them soon as they come so you can return.

It's a bit annoying to put a pair in the RJ45 at a time, but this is the new way of doing it. Everything is the way it should be and works perfectly.

Used these with cat6 23awg cable no connection replaced with different connectors no issues with cable 10% loss

These are fantastic RJ45 connectors, and to date I've achieved 100% success when using them. Before buying these, I'd stupidly (lazily!) tried some crimp-free RJ45 connectors that were absolutely useless with 23 AWG solid copper CAT 6 cable. They had a near total failure rate due to their poor design, and were (relatively speaking) stupidly expensive. So, I bought a set of these connectors, because I had wires poking out of walls, and wanted some connectors that might actually work and with a high success rate (there wasn't that much cable poking out of the walls!) These are superb. It is actually impossible to go wrong with them, if you take a bit of time and follow a few simple steps. Firstly, don't forget to buy strain-relief boots, and then don't forget to put them on the cable before fixing the connectors (I know you know not to forget this, but everyone does at some point.) Then, strip and straighten the wires, untwisting the pairs to make nice straight conductors. Arrange them in order, and while holding them flat between thumb and finger, cut them at 45 degrees. This will make it easy to push them through the connector. Push them through the connector, and make sure that they are (a) in the correct order, and (b) all the way through. The nice thing about (a) here is that the solid colours are separated from the stripes due to the offset holes, which accommodate the 23 AWG wires perfectly. This makes it a cinch to check the ordering before crimping. Then crimp using a decent through crimping tool which also trims the cable. If you follow this simple recipe, then you will never have a bad crimp. Seriously, I have yet to have one of these fail, and I've been sticking them on patch and in-wall cables throughout my house. Without doubt, crimping an RJ45 connector has never been easier, and I recommend these without any hint of reservation. They're brilliant.

Really easy installation if you have the right tools.

Ottimo

Been using these with CAT6. Been adding more connections in my house to find out I was out of Tips. These have worked great! Not one bad crimp. These make it super easy to check before you crimp.

Bon produit

Il faut faire attention à la taille des câbles mais si on respecte bien les spécifications le câblage se fait sans aucune difficulté. J'en rachèterai

I likely will give a follow up more than on time delivery experience. The experience is good. A satisfying purchase is my experience.