The Original Grip Puppy Comfort Grips

Great upgrade for $20. My stock scooter grips were crappy, soft gloves could grip them but my more protective hard leather gloves didn't grip well, causing hand fatigue on a half-hour commute. The texture of the grip puppies makes a huge difference, now I can simply roll my palm on the throttle for effortless control, without needing to squeeze with my fingers. The larger diameter is an improvement as well, for comfort and control.One thing to note: you may need to trim them to make sure you're not getting accidental cruise control. The puppies are just slightly longer than my throttle handle, so it was gripping the knob at the end of my bar and holding the throttle open. Had to take off a quarter inch, but even with that, install took only a few minutes. Couple drops of water-based lubricant and they slid right on. 5/5 product

These things are great - I put a set on one bike and have now ordered a second set for another bike. They really make small bars feel more substantial and they reduce vibration. I have some hand issues with arthritis and they seem to help with that as well because I don't need to close my hand as tightly.

I have grip puppies on two of my bikes. When I bought a new bike I took the long way home. After this ride without grip puppies I couldn't wait to get them installed. The really help to relieve the hand stress.

Give a medal to the guy that suggested using hand sanitizer to fit on the bike. Literally seconds. You don't have to cut it, just use the hand sanitizer and slip it all the way. If you're stuck mid way, the nozzled bottle helps a lot to apply specifically to the inside of the grip. Quality is not the best, but seems like it will last a while. Comfort improves a lot. Was able to ride for over 10 hours. Before this, I felt pain on my left wrist after an hour of riding.

Great quality product. Fit perfect on my 2020 BMW R1250R. Installation was not as hard I had read about. I soaked the grips in hot water for about 10-15 minutes, put some diluted dishsoap around the inside of the grips, and installed them. I was using rubber gloves when I tried to put them on and was losing grip because of the soap. So, I got a dry microfiber rag and with that, was able to get the grip I needed and they went on, with some difficulty, but fairly quickly.I have large hands and these make the grips feel perfect, instead of like I'm riding a toy.

Can't review them, if I haven't received them. Expected tomorrow, if it doesn't rain again.The pictures look comfy though.I gave a 5 star , because you tried.

I used just a little soap in a spray bottle with water spread my finger and wiped the inside of the handlebar grip and it slid right on over the factory handle grips I let it dry over night and the grips are great feel wonderful in my hands and the vibration is gone worth every single dollar and they look stock I used these on a 2024 Honda Rebel 500Just a little Update the grip covers are holding up amazingly they work great you can get them wet without fear I've had mine in the rain and experienced no slippage of the grips upon the handlebar they are definitely on there I've had them on my bike for just over 400 miles I will update if anything changes but so far I would absolutely recommend buying these

Probably the best think I’ve added to my new T7. It’s the little things that matter the most. My hands feel better.