Keyecu Flip Remote Key Shell Case Fob 3 Button for Bentley Continental GT GTC Mulsanne 2004-2016 P/N: KR55WK45032 (Empty Key Shell ONLY)

Great product! It fit perfectly unlike others I’ve ordered before. The housing opened easily without me having to pry too hard and damage it. My factory key buttons would no longer function and I was afraid I’d have to replace the whole board. I put the board in this fob and all buttons work perfectly!

Works great! My Old key fob connections were worn out, so I could not lock remotely. I got this and my husband assembled it using the key from old key for and it works remotely again. Much less expensive than ordering new key from Bentley.

This mold is NOT an exact of the original and does not fit the circuit board without slicing the tab a little (circled in red in the picture). Also, if you're using some old parts with these new parts (like I did to keep the Bentley insignia and the original cut key) note that they aren't compatable. For example, this new mold did not come with the three small screws securing both ends, but just one center screw so the ends leave a small gap. And the original screws DO NOT fit in the new mold's replacement holes - at all. Finally, the T section that aligns/secures the original back with center section does not fit without trimming. Even then, with very meticulous trimming it was loose so I had to add a couple dabs of glue to hold it. Having made several adjustments to the new mold, it is better looking than the old, worn fob I received when I bought the car but just know it is not an exact replacement.

Perfect fit!!! I had a busted bentley continental 2015 key. This was easy to do. However i couldnt get the red emergency button to work. Instead of having a another metal key made by the locksmith I was able to put in the original metal key. It doesn't pop out smoothly though but it's fine. All the buttons are nice and firm. The key is solid. And it looks exactly like an original bentley key with perhaps the smallest size difference.

exact fit and finish to the original, it is a little bit of work to dismantle the original fob and replace the shell.

Very good product

This case does not fit the Bentley circuit board properly. The board has no seated position, so when you assemble and tighten screws and place sides back on, it smashes the chip board causing door lock button to press non-stop. Wont click. Even worse, the tab on the battery side of case will hit a chip on the board and break it off. Causing your board to NO longer work, now needing your car to be towed to the dealership for a new key programming. These should NOT be sold.

Just needed instructions , product was perfect

Refurbished Bentley key does work.

Doesn’t fit correctly the electronic board of the original Bentley key. Buttons not internally aligned to be pressed. Simply Unusable!!! No badge on the back of the shell.

Returned as not similar to original key