YUNGUI 5PCS Perf Board Stripboard,9X15cm Copper Circuit Board Single Sided PCB Board Breadboard For DIY Arduino Soldering and Electronic Experiment

Nice boards, the holes line up well with DIP chips and other standard parts. I also like the mounting holes that are provided.

Works as expected

I have a prototype project that I need to solder now. I like the strips of copper running the length of the board. This will cut down on some jumper wires needed.

I like how these are patterned out like a breadboard! Great addition to my Electronics Laboratory Bench!

Easy to use. Great value. Stands up well to heat. Pads are well attached.

The board is thin but sturdy, however the copper leads are very delicate. Too much heat and they burn right off. A small tug from a wire can easily peel them off. Also it's not easy to fill in the holes with solder. On the positive side, it's very easy to make an intentional break in the circuit by cutting or scraping a lead with a hobby knife, and it's very easy to use a Dremel to cut the board down to a smaller size. I don't think I'd buy them again, but they're fine for small projects and temporary mockups. Comes in a pack of 5, 15 x 9cm, 1.2mm thick, 48 columns by 30 rows. (I purchased these to build the 1980s Usborne Robot because the dimensions are similar to Veroboard and close enough to the book's schematic with slight alterations.)

These boards are quite nice. Beginners may have a tough time with it, but if you can solder cleanly and precisely, they are much better than some of the other lower quality strip boards I've purchased. Good for the money for sure.

Would like to have boards available with power supply routing tracks already etched around the perimeter or half way around the perimeter of the board