Heschen DC Solenoid Electromagnet, Push Pull Type, HS-0530B, DC6V 3.4A, 10mm Stroke, Initial Force 0.5N, Max Keep Force 5N, Open Frame, Linear Motion

I used this to lower a "bar" on a bar billiard table I constructed. Like others I tried with a AA battery pack of 4 cells but it couldn't drive it with much force. I ended up with a 12v 1A power supply and this worked as long as I kept the friction to a minimum. So I started trying to use the shaft directly on a piece of MDF but ended up connecting a small flat plate on the end of the shaft and this works fine. So depending on application, try and get a 12V 1A supply and consider any sideways force or friction carefully and it should work.

Everything perfect

VOLTAGE As per description. Got it to work as low as 4V and as high as 12V (very hot!). I noticed some people mention it only working at 9V+, however unless they actually have a broken product I presume they've naively used a couple of AAs and so have met the voltage but not the amperage requirements. CURRENT As per description. 1A minimum. More when it's hotter or using more voltage. FORCE As per description. About 500-600g. LIMITATIONS At 1A+ the solenoid gets untouchably hot after being on for any length of time. So while suitable for brief moments (i.e. power to *unlock*), the solenoid isn't really capable of operating in "always on" mode (i.e. power to *lock*), unless you want to melt things. DESIGN Input wires are just sellotaped to the body, making it more oddly sized than it should be and requiring a little reworking in order to get it to fit into a sized container.

They are amazing little things they are quite small wasn't expecting it and they do get quite hot after continuous triggering other than that it is a ok small little thing

Should be a good bit of equipment for my Halloween display

Very weak. Won't operate any load

It's working but not with 6V, not even with 7V, it doesn't even move but with 9V in the end. All god except the voltage. I will need to change a couple of things in my project to make it work with 9V but is not the end of the world. 4 stars because of the voltage aspect.

I bought this solenoid to use in an automation project with a Raspberry Pi. The solenoid seems very weak and often only partially withdraws the link without any load. Totally unsuitable for the purpose.

parfait, mais , ce qui est normal, la version 12V DC est plus puissante. Choisir donc entre le 6 et le 12 V suivant la puissance requise.

Det finns gott om ideer på youtube som visar vad man kan göra med sanna magnet"ventilar". Just denna versionen är dock väldigt klent och rör sig verkligen maximalt en centimeter - och detta med en mycket låg kraft. Förslag som att dra en skjutregel och göra på så vis en dörr eller grind smart behöver en mycket större version av den hardware.

Hat schon richtig Wumms! Allerdings braucht es schon die Amperezahl, sonst hat er nicht die Kraft

Estaba buscando un aparato de estos que fuera de un tamaño pequeño y potente he dado con el y tiene una muy buena calidad está bien construido y lo utilizaré para una instalación electrónica que tenía abandonada por falta de este componente también sorprendido por la rapidez que el paquete ha llegado, menos de 24h

Produit conforme, fonctionne bien, même avec une tension inférieure à 6V (répond avec un accu 18650) - Seul petit bémol : le ressort est faible, probablement à cause de la faible tension de fonctionnement.