5pcs Mixed Universal Carbide oscillating Tool Blades Set for Tile Grout Mortar Concrete Masonry

I used these blades to grind wood flooring adhesive off a section of my floor where I needed to replace boards that were damaged by a water leak. These grinding blades were effective and lasted for a long time. I was able to effectively remove the old adhesive and then glue new boards to the foundation. I am pleased with the outcome.

These blades worked great and are a great value. I used to remove thin set from the back of shower tiles. I bought the five pack because I thought based on price the blades would not hold up. But I only needed one of the blades to complete the entire job. They held up great and cut through the thin set great. Definitely a great buy.

I took a chance on this purchase, it's an incredible value. I was happy to see these are incredible add on to my Dremel oscillating tool. The carbide grit is part of the tool that holds it, unlike sandpaper that relies on glue to hold it in place. I've been using it on wood and it seems like this grit is there to stay so I may not need to get more, and this purchase came with a few blades. But it requires the use of a small adapter as this is a universal tool. It's a very small u shaped clip that is placed under the Dremel clamp and the tool itself., it's a bit difficult to place but once in place never comes loose. That's just a minor annoyance though, this is an incredible value.

I wish i had discovered this product sooner!! They last and last. Although they are designed for grout removal I found out that they’re great for woodworking as they act as a rasp and are great for removing epoxy blobs— saves a lot of sandpaper! The small pointed one has carborundum on both sides so you can place it between two pieces of wood that don’t match perfectly and in a few seconds that problem is solved. They’re great.

After changing our deck boards, the concrete ramp was too high by about 1/8". I had to trim that down for a width of about 1" and a length of 36 inches. This certainly was not as fast as a grinder would have been, but it did get the job done for far less expense than renting a grinder, and also allowed me to get in to some tight corners. It was almost frustratingly slow compared to a grinder, and it took a very long time to cut down the rocks that were in the concrete, but it did get the job done and there was not enough wear to the tools to be of concern. It took about 2 hours to finish cutting this down, but I saved a lot. The one picture shows the sharp edge which was too high, the other picture is after cutting it down. Now I can fill the gap with concrete filler and it will look great.

First time user with this type of tool and I was impressed how these blades performed.

good stuff but expected more. The blade is too thick. But in general you can use

Arrived on time. Works as expected.

Good quality and good price. Would be great being able to purchase only 6 triangle pieces as I never use the round one

I’m removing paint and rust from 80 feet of intricate wrought iron fence. Ain’t fun but the spade blades will get me to the end assisted by abrasive disks on my grinder for the flat surfaces.