iGreely Dual Positive/Negative ATC Style Fuse Holder 10AWG Wire with Ring Terminals and 45A Connectors for Automotive 2ft/60cm

Good construction with heavy 10 gauge wire.

Use to connect a battery to a solar power station to extend the battery life. Works as intended and connectors are good quality.

As with all Amazon products, they push for a review pretty quick. This is a good quality, accurate gauge wiring. If it causes issues, I'll be back but I don't expect trouble. Looks solid!

I needed a power cable to go from the battery to my HF Ham radio and this fit the bill because it had Anderson Powerpole connectors. My only comment the ring connectors on the battery are almost too large to fit my Eco-Worthy battery. A couple of washers solved that problem.

Using this to connect solar cells and 20A solar charge controller to RV lead acid deep cycle batteries. Hoops fit on the batteries no problems. Other end has 45A Anderson connector. All appears to be heavy duty construction. Two built in fuse holders, one on positive and one on negative. Comes with 15A, 20A and 30A fuses.

I purchased two of these cables used to chain 2 additional batteries to my Goalzero Yeti 400. I was very happy with the purchase, since they worked out flawlessly. I chose these particular cables, because they were 1 foot longer (and the longest I could find) than another product.There was 1 little issue that was easily fixed in a few seconds.. The +/- anderson connectors need to be individually turned (by sliding down the plastic/rubber sleeve & sliding it back up when done) to place them in the correct position to connect. Out of the box, the connector pins are not facing the same pin position as the one on the Goalzero.

Quality copper wire, terminals and fuse holders. but the Anderson Power Pole connectors were assembled improperly. The Red and Black Power Pole connectors should be connected side-by-side in the standard fashion (documented on Anderson Power Pole website and others). This item came with the connectors attached one on top of the other, thus will not mate properly with a standard pair of power pole connectors. It is relatively easy to rectify - you can detach the connectors from each other and re-attach in the proper orientation - but you kinda got to know what you're doing.

Terminals and power pole connectors, plus three fuse sizes available for 45 Amp rated wiring.