superlin NEW Replaces For HAIER THERMOSTAT CONTROL RF-7350-101 WPF27.5S-923

I couldn't find the WPF30 series control that was the original in this small cube Haier fridge. The WPF27 was similar enough from the pictures I ordered it. Turns out the body is exactly the same with the narrow terminals, same length control shaft, and the shaft flat is clocked the same as the old unit so the control knob points the right way once installed.The only real difference I found is the capillary tube is longer, and the flexible plastic sleeve goes nearly full length on the WPF27 where the WPF30 I removed, has a short section of clear sleeve.When you remove the old thermostat DON'T change the bends in that tube, use the old one as a template to bend the capillary tube on the new one. Due to the extra length I put a slight "S" curve in the length of tube at the back of the fridge. Install the new unit into the plastic housing, put that in place then the plastic conduit holding the power line and capillary. Then the fun part - getting the end of the capillary to stay in the plastic retainer as you contort your hands to snap the retainer into place.It's been about a week now and works great! The temp dial is set to 3 1/2, the fridge stays about 37 to 38 degrees (I used a temp sensor from my weather station to monitor) and no more frozen drink bottles.

Fixed a small fridge without much difficulty. Direct fit…recommend.

Exact replacement, 10 minute job, start to finish.

I have a Black & Decker mini fridge with a compressor that wasn't turning on. I changed out the thermostat with this item as well as the starter relay and overload protector (bought separately) and the thing started right up! It's nice and chilly now. Happy with my purchase!

in my Kenmore 183.92779 mini-fridge made by Haier. It saved this old mini-fridge from the scrap heap, after the old thermostat failed, making this min-fridge into a mini-freezer. And I would buy this again. Installation was generally pretty easy but routing the power wires and the sensing tube back through the plastic conduits wasn't. Make sure you take a photo of where the wires connect to your old thermostat to use a reference before you start taking the wires off of it.

Replaced in an old rv fridge. Within6

Just like one of the previous reviews, my old Frigidaire mini-fridge was freezing everything and constantly running. It had a thermostat just like the one posted in the user-posted pic (different numbers)...2 prong, with a defrost needle. Instead of spending $200 on a new mini-fridge, I thought I'd give this option a try.The old thermostat came out easily. The new thermostat went in just as easy. I glued the blue defrost button inside the temperature control knob. I've found a setting of 4-5 on the new thermostat is about 35 degrees.So glad I tried this option first!

I ordered this thermostat for my mini fridge because it was freezing everything, I wasn't sure it would fix it because I didn't know if it was the prob or not!! After some research I decided it was probably the problem. This thermostat fixed it and my mini fridge works great now