30pcs 12 Volt 1.8mm White LED Lights Emitting Diodes Pre Wired 7.9 inch DC 12v LED Light Clear Lens Small LED Lamps

Used then on a popsicle stick ferris wheel and they worked great.

Fantastic item it does exactly what it says it does for my needs that fits. Perfect thank you so much.

LED lights work great. Used them for a science project to illuminate a sun. Light color was warm color. Bought a breadboard to accompany lights.

I think these are a good value but a little too white for my application.

These things are bright!

The Led's are well made. Connect to a 12-volt DC power supply to observe full level of brightness.Even though the case is clear the light emitted is RED.

For those doing 3D resin printing, with 405nm resin, I can confirm that the UV 5mm does work to cure the inside of resin prints. An important step to prevent liquid resin from reacting with the outer shell of cured resin and resulting in a physical failure of the model. The two cracked models show what happens if you don't cure the inside of the prints. To test, I dipped a mini in the resin vat, let some resin drop on the tray and then set up the LEDs near the mini and the puddle. They were both non-tacky within 5 minutes. For connections, these LEDs already have a resistor and I bought the following power supply which has an adaptor with screws for bare end wires. I twisted the groups of wires and put them in the adaptor. Plugged in the adaptor and I am set to cure inside models. No soldering, as you will see if you YouTube "resin curing snake". I only put in 5, but it's a 1A adaptor and the LEDs only use 20mA so you could attach a lot of them.Power supply:https://www.amazon.com/dp/B07C75RT38?ref=ppx_yo2ov_dt_b_fed_asin_titleHappy Printing!

Great little led light for diorama. Easy to use, just hook it up to a 12v dc power supply. I made a spot light with it by placing it in a shrink tubing to focus the light. Worked great.