1U Brush Cable Manager Horizontal Rack Mount Cable Management Panel with Tidy Brush Slot for Cable Entry for 19-inch Server Rack or Network Cabinet, Disassembled

The brush fibers are attached to a plastic strip that is held in place by three small philips-head set screws on the back of the panel; these can be loosened and the fiber strip repositioned if necessary. The fibers were off-center but easily fixed in a moment.I assembled the brackets to the brush plate but left the screws loose to make it easier to fit the whole assembly to the rack. Once I had all of the screws in place, I did my final alignment before tightening them down.I think the price is a bit high but that's true for all things rack-related. The quality of materials is good and that's the primary concern with a simple piece like a brush panel.

Like the build quality, and enjoy how it keeps my network rack looking great, where the cables pass through, hiding what's behind. Would definitely buy again if I needed another.

Good brush panel. Screws that hold the brush in are too short and fall out.

I used this cable manager to run the fiber cables in my rack from my switch to my hardware. There are two sections on the brush plate which helps to keep your cables in place. On the back there are spots to attach the cables that you've passed through with a zip tie. You do have to assemble it by attaching the ears to the brush panel, but aside from that it's pretty much a set it and forget it.

I got this to clean up my networking center at my home. The brush cable management was super easy to setup and install into my rack. I like that the brushs are thick and strong for keeping the cables in order.