POLE.CRAFT IWB/OWB Magazine Holster Kydex - Mag Carrier Fits: 9mm .40 Double Stack / 9mm .40 Single Stack - P365 1911 Glock 19 19X 17 26 27 28 43 22 23 25 26 27 31 32 33 34 35 37 38 Glock43X .. Mag

Fits my Sig P365X Macro magazine very well. High Quality materials were used in this. I use it every day. Fits comfortably and conceals well

It is bigger than described. I just had to remove the two screws and used a box cutter to cut off a little bit of the rubber bushings. Tightened down again and it works good.

Got my Pole.Craft Kydex mag holder (IWB/OWB) for my DW 9mm 1911.I like that its size is small and more easily concealable than my leather OWB mag holder. It also fits on my standard belt as well as my double-thick CCW belt- just like Pole.Crafts holster I have.What I did notice is that my mag slide into (and out of) the holder w/o restriction- not good! Tried tightening the 2 tension adjustment screws and it made some difference but not enough. Undid the screws and the tension grommets were made of semi-hard rubber. Took my razor knife and cut 1 of the grommets in half. Reassembled the holder, snugged the adjustment screws down and viola! Enough friction now developed to hold the mag in place yet allow for removal.The mag holder edges are rounded and the mag sits in the holder without either the mag or rds being exposed out of the open bottom. Very happy now!BTW, my mag is a DW, single-stack 9mm, 8 rd 1911 style. Now have both the Pole.Craft holster and mag carrier for CCW use.

Had to trim the rubber spacer to get good retention on my 17 round vp9 mags, if it wasn't for that they would be 5 stars.

We ordered this 2 years ago and just recently lost a screw on the clip. I contacted the seller to see if they sold replacement screws and without hesitation they sent us the replacement screw. I would buy from this company again. And the customer service is amazing. My husband said it’s the best mag holder he’s had

Bought for G19 double stack & works just as it should. Mold & TIGHT just as I expected. However the G43x single stack does not fit & can not be adjusted to anything considered tight, snug or barely. This magazine holster described as fitting a G43x is absolutely incorrect .

As others have stated in their reviews this magazine pouch is slightly too large for a 17 round Sig P365 Xmacro magazine. The magazine fits well inside the pouch but has zero retention without modification. I did what at least one other reviewer said, cut the rubber washers between the tension screws in half, which made it work. The geometry isn’t molded and is a very generic fit but it gets the job done. I’m torn on recommending this as it does indeed work after modification but not sure it should be marked as compatible with the P365 Xmacro. You can decide if modification and a generic fit is okay with you.

I have no dislikes. It is ambidextrous; however I set it up for IWB on the right side (lefty) and when I want to take it out and wear it OWB I just flip the magazine around. Some others you have to flip the belt clip to the opposite side, when you switch from IWB to OWB, so that the magazine is easy to insert, but not this one. The magazine is equally as easy to insert and remove no matter which way I wear it. So that’s very convenient.