StarTech.com Server Rack Depth Extender - 1U - 4in / 10 cm - TAA Compliant - Recessed Rack Adapter - Rack Mount Adapter Kit - Network Rack Extender (RDA1U)

This worked perfectly and saved me sending back a battery back up unit.

I have a 4 post cabinet that was just a few inches too shallow to mount the DELL rack rails for my server. I put these on the back of the rack to extend it, and the rack rails connected right to it.. Sturdy as if it was supposed to be like this.. I'd have no reservations about using these on every server in the rack..

It says it's a rack depth reducer/extender, and it does that. The only problem is that the equipment side uses rack nuts, which are a right pain. Fortunately, once you do manage to put them on you won't be bothered again. Sturdy enough for a 1G switch, and puts enough distance between the rack's back door and said switch so that I can actually cable it.

Great product at a reasonable price

Exactly what I needed to fit my NVR into a network rack that didn't quite have enough breathing room in the back.

I got this to extend one rack component out to the back a bit (I could have reconfigured the whole rack since it was length adjustable but didn't want to throw out and re-do a custom made wooden top I had fabricated for it). It works but mounting it is a bit awkward. Plus no matter how you fix it to the rack, it adds just enough thickness so that my component wouldn't properly clear the back mounting bracket anymore. Took a lot of finagling to make that happen. That's its only design flaw as far as I can see. Other than that did what it was supposed to do.

says what it does, does what it says. you'll get some sag if you use it in extension mode, I had a spare structural support piece that I put one rackspace below my server on the backside that keeps it level.

I wish I had known about these years ago. They're perfect for my custom TV cabinet server rack. I got lucky where the top two U's were clear of the metal pegs, otherwise these Z-shaped brackets wouldn't be aligned. I reversed them so my patch panel and switch can be recessed into my cabinet so my SFP modules don't bump into the cabinet door.

Fait le travail, un peu de jeu une fois monté mais rien de très choquant.Attention les vis fournies ne sont pas de la plus grande qualité et une main trop lourde risquera de « foirer » la tête !

Using these brackets works both for extending a device out from the rack but also if you want to recess a device inside of the rack - for example a power strip.Pricy but work as advertised and I see no sag for my Switch and Router that I'm using these on.

These bracket let me fit a 14" deep 1U server into a 12" deep rack. I am very satisfied. They fit right away, no need to fight to install them as other says. They are bent with an angle greater than 90 degrees, it make the bracket act like a spring so it can be adjusted.

These are really handy in a limited space rack.

Habe damit Patchbay und Switch weiter ins Rack hinein verlegt und bekomme nun die Türe vor den Patchkabeln zu. Konnte keine Einbußen in der Stabilität feststellen. Sehr praktisch!