Hole Saw Dust Bowl, Drill Dust Collector, for Installing Recessed Lights and Works with Hole Saws Less Than 6 Inches in Diameter (Hole Saw Not Included)

I have the Spyder quick change hole saw and the shaft is larger then the bearing in this cover, pretty sure it's for 1/4" or similar drills/shafts. Popping out the bearing made the shaft fit fine. Once you pop out the bearing you have to hold the dust cover in place or it'll try to spin but that's negligable compared to the usefulness of this cover. This made drilling 100+ drywall holes so much nicer, keeps all the dust in the bowl and clean up it 100x easier.

I install a lot of recessed lights. All of the dust collectors I have tried have been terrible in design. The friction from the chuck destroys them after a few holes. Put a bearing at the arbor hole! A no brained right. Well these guys finally did it. I bought three hoping they would get me through a day and the first one is still perfectly fine. Cost less than the junk ones and you can change the saw to cut whatever you need, not like the completely useless Milwaukee. Yes, I even tried that 50 dollar waste of time and money. Can’t cut 6” with it though, only drawback but knew that going in.

I returned this product as I did not realize it came in two pieces and the bottom (straight part) screws on to the top (bendable part). Because they are both plastic they do not hold together and I would never want to use this on a project just for it to fall open and still leave dust all over the place.

Seems a bit flimsy, not sure how durable it will be. I guess it's good for a project hear and there

Says ok for up to 6” hole saw but a 6” hole saw is really too big, started cutting into the dust catcher on second hole I drilled, had to toss it. But I would say great for a 4” hole saw.

Bottom unscrews to make it easy to clean out. Works great to make clean up easy.

I bought this on a whim because I was installing 27 can lights in my new to me home. This probably caught 99% of the dust.Just watch out because the dust likes to hide in the corrugation and dump all over your floor when you least expect it.If fit my 6" whole saw pretty well, but I wouldn't go bigger than that. The hardest thing was lining up the center bit on my mark with this on.

There is a bearing to help to help reduce friction on the drill