Thermalright ASF-RED AM5 CPU Holder, Corrective Anti-Bending Fixing Frame, AM5 Full-fit Fixed Non-Marking Mounter, AM5 Anti-Bending Contact Frame, CPU Cooler Standard.…

I’ve installed red one on my 7900x with CM 360 atmos. It made the thermal paste application much less messy as stock application sometimes hard to clean win capacitor area, also it also looks cool. I have seen a drop of only 1-2 degree just because of better mounting mechanism. but I would say 1-2 degree can be even improved just by properly tightening screws in stock mount. I think I just bought it because the Ryzen 7900x temps are so high its just a peace of mind to install this as it cost 0.3% of the complete setup cost. If you care just buy it.

Installed on Gigabyte Aorus X670E motherboard for my Ryzen 9 processor.Made it easy to apply the thermal paste without worrying about it spilling overDefinitely reduced CPU temps as latest ryzen processors is known to touch 90 degrees centigrade. Dont know how much since I don't have a base line and my processor has not touched 90 yetLooks much more sleek as compared to the default processor bracketsComes with its own thermal paste (did not use it)..so a spareBuilt is high quality and hardly to see any gap between processor and holderIncreases surface area for larger cooler plates (AIO, air cooler)Suggest to watch videos from YouTube about installation and do not over tighten the holding screws.

Although AM5 CPUs don't require contact frames as Intel CPUs do, it doesn't hurt to apply even pressure to the CPU's installation. Additionally, these will help prevent the thermal paste messes of old, where extra paste ends up in the little edges and corners of the AM5 IHS, and will be a pain to clean up later on.I have a few recommendations for installing these:1) Watch the GamersNexus' video on the Intel version, which has a helpful installation demonstration section that is basically similar to the AM5 version.2) Whatever cooler you are using, make sure to have the standoffs installation hardware installed BEFORE removing the original AM5 CPU retention mechanism, ESPECIALLY if you already have the system in the case like me. Otherwise, the AM5 backplate will fall off, and you will have more work ahead of you.Overall, does it's job well, looks cool, and helps with thermal paste cleanup and prevent messes. Highly recommended.

رائع ما شاء الله

جيد

Lower temps with ryzen am5

Aunque solo son un par de grados, si es muy útil, además de que asegura que la pasta térmica no entre en el procesador.