BOSS Fv-30H High-Impedance Foot Volume Pedal

Works well. Even volume change from end to end of travel. Feels good and solid.

typical boss great

Works fine. No minimum setting so you have to be careful not to go silent.

No longer needed, sent back

Well made, and does just what it should, but not as useful as I thought it might be. That's my problem, not the product's though.

... most of the volume change takes place within the last tiny fraction of the pedal's travel i.e. it's very non-linear. I'll get used to it, I suppose, but it's not as good as the FV-500H in this respect. The pros are that it's very solidly built, the action is smooth and it's small.

This is a sturdy and well functioning electronic item, but the 'push/pull' inner mechanism - though well made, is 'sticky' sounding and noisily off-putting, if playing at quiet [home] volumes.

I mounted two to a pedalboard to use as a volume control for a DAW and an Allen MIDI module, part of a virtual pipe organ in a church. Hence they must be dead quiet and increase volume smoothly. No 60 cycle hum.

Great volume pedal. I've got my loop send going in here, so it controls the levels going into the mods and reverbs. Typical ambient swell position.Pros: extremely smooth operation, feels great and doesn't use a string that may break at some point.case is built like a literal small tank. This is typical BOSS construction which is unbeatable.Good size. Fits in the corner of my board without taking up too much space, but also a nice lever length so it doesn't feel too difficult to create nuanced expression.Absolutely quiet when turned down.Dual I/O for stereo if you want it!Cons:No adjustment of the curve or the min/max. I'd like to be able to set the heel down "off" to a minimum signal.I don't like the I/O ports being on top. It is going to push up into your top row of pedals no matter what. Use 90 degree cables here for sure, even then I've barely got room between the cables and my mini format compressor above it.No tuner out. I know the low impedance version is probably going to be on the chain somewhere you wouldn't normally use a tuner because the signal is not clean... I'd like the option though if I wanted to place the low Z in second position after a buffer. Treating it like a high Z before the preamp chain. Solution will be to get a high Z second pedal lol.

Llegó a tiempo

Very well built pedal. But the range of volume is not spread evenly over the sweep. Most of the volume cut, like about 80 to 85% happens within a short sweep from the toe point. After that it cuts rest of the volume till heel point. This makes it tricky to use quickly to find required volume. I wish the volume cut was more evenly distributed. That would have made this pedal perfect. While I don't exactly regret buying it, I will consider something else if I have to buy again. But better quality ones are priced higher than this.

ハイインピの方と間違えて買ってしまったので、泣く泣く最後尾に繋いで使い始めてからもう手放せなくなりました！ギターで使ってますが歪みでも空間系でも、音質を変えずただボリュームだけを落としてくれて最高です！材質もかなり頑丈！