MASO 12V Cooling Exhaust Fan Air Vent Ventilation for Motorhome RV Caravan - Strong Wind Type
Item Dimensions D x W x H | 6.89"W |
Voltage | 12 Volts |
Switch Type | Touch |
Indoor Outdoor Usage | Outdoor |
Control Method | Touch |
Is Product Cordless | No |
Wattage | 3.6 watts |
Number of Blades | 7 |
Air Flow Capacity | 3.3 Cubic Meters per Minute |
Power Source | Corded Electric |
Room Type | Kitchen |
Additional Features | Lightweight |
Recommended Uses For Product | Exhausting, Cooling, Air Circulation |
Mounting Type | Free Standing |
Controller Type | Button Control |
Electric Fan Design | Exhaust Fan |
Style Name | Modern |
Color | White Silent Wind |
Blade Material | Plastic |
Material Type | Plastic |
M**Y
Unfinished product
The product initially looks good except there is no inner cover for the fan, you just get to see the black fan blades which isn’t so good if you have nice decor in your bathroom, it all looks very unfinished from inside
C**Z
Schönes Teil, leider nicht sauber nachbearbeitet.
Material sieht ok aus, scheint stabil zu sein. Werde es jedenfalls im Camper einbauen.Aber derjenige der die Kunststoffteile aus der Maschine genommen hatte, hatte wohl einen schlechten Tag. Siehe meine Bilder. Das sieht aus als hätte der den überstand abgebissen anstatt ihn sauber zu entgeraten. Das werd ich dann wohl übernehmen müssen.
H**T
Belüfter wie beschrieben
Das Produkt entspricht der Beschreibung.Die Lieferung fand ich mit drei Wochen zu lang.Leider liegt keine Einbau- und Bedienungsanleitung bei.
C**D
Ok
Ne vous attendez pas à une tempête, ça tourne...
M**O
Bathroom vent for a Camper Van
Installed in the bathroom of my camper van. Pretty straightforward. It’s a small fan but does move some air. It’s not silent, but not too noisy either, actually quieter than it sounds in the attached video. Of course the scary part is cutting a hole in a new van! I made an inside frame for the screws to grab so they were not just being held my the metal skin of the van. The only “junk” part is that the fan is exposed on the inside and has no protective cover to keep things from hitting the blades and causing injury or hurting the blades. I fashioned a housing and glued in a piece of plastic mesh that I think will do the job. Wired it to a small rocker switch that runs off my auxiliary battery.
Trustpilot
1 week ago
1 month ago