42-48_Dual-axis Stepper Motor for 3D Printer

I love this thing! It was a great intro to klipper. It can be slightly frustrating due to the lack of certain details in the setup process, but since the newest firmware update it has been much easier. It now allows for 4 printers and has most Ender 3 and 5 models. It takes the work out of building config and firmware files. If getting into the deeper side of 3D printing is what you want without going the Raspberry Pi or Linux route, this is the way. Only slight negative is it’s not quite as open source as I’d like.

The media could not be loaded.  Metal extruder doesn't work properly. I unboxed the machine, assembled it and started to print my first model and observed that the extruder is not feeding the material. There is no after sale service. Not recommended to buy.

Provide a comb for sticking the mat, or directions for sticking

The media could not be loaded.  Bought this for Rs. 23.5k guess what I'm Fully satisfied with my 1st printer not hard to use! My first prints rabbit & benchy turned out perfect and other models too! No problems with build plate, it's good to have magnetic plate which is removable. 1 more thing it's noise is literally less than what I thought it's really low. Installed some custom lights to it. Best in class printer in this range! I would recommend you buy this instead of ender 3 with little more money you can get a best product!✨

I ordered a Creality Ender 3 Glass Bed Upgraded, 235x235 4mm.received a glass with a usage signs on it.no holding clips, only glass.

Best printer in its budget. Assembling it's a pain as well as fun. Refer few videos before you start assembling. Because perfect assembly will lead to perfect prints. Quality is at its best. Fan sound is bit high but if you are keeping printer away from your room then it's not a problem. Motors are smooth no sound at all. And the PLA which comes with combo works great.

Really good glass bed, i had warp bed issues, this fixed it and i get good prints now, i have the standard ender 3.

I bought this printer hardly 3 months back and it has started malfunctioning in this time only, I am unable to print anything, which has been really disappointing because this ‘Crealty’ doesnt have any service centre in Delhi. I am facing alot of trouble as my prototype has put on hold just because of this terrible product.