OriGlamTwo Jaws Bearing Puller/Remover, Adjustable Two Jaw Puller Tool, Bearing Puller Tool, Carbon Steel Pump Pulley Remover (8 inch)

This puller actually worked for its intended purpose. Color me surprised. Sure, the nose is soft and it doesn't not come with a removable center, but what are you expecting for $20? Pulled two stuck inner wheel bearings with very small clearance and I could move onto other things. Saved me a bunch of time I would otherwise have spent fabbing a special puller.Good job, Sketchy imported Puller!

Worked perfectly. Rusted on pool motor bearing. Used a DeWalt impact wrench on slow speed because it was to hard to turn and hold by hand. Pulled it off with ease. Couple that with the fact that I ordered it at 8:00 pm last night and it was on my doorstep at 7:00 am (I paid $2.99 extra to expedite), and you can't get a much experience.

Solid and easy to use to pull bearings on my moped engine.

Worked no issues. Few screw caps of different diameter would been a big help. But that’s what you pay.

Great quality, cheap price, easy to use, somewhat durable, great size, great appearance.I used it to pull bearings in my Toyota transfer case. I couldn't get under the bearing but I was able to grab the lip of the bearing where a c clip goes. Worked great but it did bend slightly. In all fairness the book said I needed to apply heat to remove the bearings and I did not apply heat. That's a cold pull.A 14mm impact did the trick on this thing. My only complaint is that it bent, but that was a tough pull.

The jaws were very sloppy. Not even the same length. Made it a pain to use.

This tool did the job, smoothly pulling the relatively clean water pump 6203 bearing. The tool struggled a little bit more pulling the remaining inner race of the other disintegrated and corroded bearing. The tool did slip off a couple of times and the tip is now blunt, but the bearing remnant is off. It is not a forever tool, but did what was asked.

Worked great for pulling the marlin crawler dual case coupler off of my W59 transmission output shaft. There was a very small opening to get a tool to fit into, but this one did the trick thankfully.