How to use: Seal the hive to keep in the vapour, normally with a foam bung at the entrance. Add the correct quantity of Oxalic Acid (as detailed on the container) to the cup of the vaporiser. Connect up to a 12V car battery and slip the cup of vaporiser into the centre of the hive through the entrance. Seal the entrance back up. Leave until all the oxalic acid has vaporised (a few minutes) and remove. Leave sealed up for a few more minutes and then remove the foam bung from the entrance. Warm tip: 1.The red clamps - positive pole, the black clamps - negative pole. 2.Keep away from the heated housing of evaporator, to avoid burns. 3.When operating, You should protect yourself with safety tools. 4.Try not to use more than 12V or excessive voltage, otherwise, the wire may be shorted. 5.Make the wire away from the shaft to prevent melt when it heated up. 6.When working, please pay attention to observation, don’t leave for a long time,don’t forget to turn off the power when not use. 7.Please wait for it to cool fully before you start 2nd hive. Advise you can keep a wet rag handy and after disconnecting the power and pulling it out of the hive, just wrap the rag around it and it is cool enough to reload in fifteen seconds or so.
Trustpilot
2 weeks ago
1 month ago
