KT GuoMei 94.5"× 35.4" EVA Foam Boat Decking Sheet Faux Teak Decking Self-Adhesive Marine Yacht RV Swimming Pool Boat Flooring Sheet Thick Non-Skid

Prep is key! Clean the surface then use acetone to clean grease and oils then, map it out cut the edges at a 45 degree to reveal the corresponding color for the edges. Looks great when done!!

DO NOT BUY! I bought this to replace the carpet on the floor of my boat. It is difficult to tuck under side walk carpet and make it look clean. Adhesion is fair. After walking on it a couple times when we took the boat out it was dirty and hard to clean. Tried to return but seller would not accept used products back, I can understand that but I’m out $300. I went to Lowe’s and bought waterproof rubber plank flooring by Mohawk. It was over $100 cheaper, looks way better, feels good on your feet, and easy to clean. Much better option! Stay away from this for boat flooring.

I used this on the floor of my aluminum Jon boat. It was easy to work with and it looks great. It's also pretty tough and there are many other uses for your leftover pieces. Another great use for this product is on the floor of your bathtub. The adhesive backing is far superior to those cheap tread stickers that one would typically use in the tub. And it also provides nice cusion. Great product! Well worth the money.

I was skeptabble about a "peel and stick" floor for my boat. I have had it in place now about 2 months, through a lot of rain and moderate use. It looks great and feels great under foot.Before installing, I washed down my fiberglass deck with acetone, let it dry , then applied this product...takes a little bit of planning to keep the pattern stripes aligned on a boat floor that is not square but is doable. I would recommend this product

I ordered 3 rolls and had some problems with the adhesive peeling off the back I contacted the company and had two replacement rolls at no charge in two days. I was very happy on how it was handled and how it looks I will upload pic when done.

This stuff in RED fades out super quick! Not happy at all! It’s going to be a job to pull it back up! As you can see from the photo. The faded side had been put down only a weekend before the non faded side.

We got this for the back deck of a pontoon boat. I fabricated three doors that fit across the fuel tank storage and engine using marine-grade plywood. Similar to the upholstery sundeck many pontoons have. The product was easy to handle and install. I would not feel comfortable using the adhesive on the back for wood, but we use aluminum trim to hold down the edges. I just installed it and haven't had a chance to test it on the water yet. The product looks great, feels nice and should hold up. I ordered the light gray/blue stripes.

Hubby requested this for his Gheenoe project. He needed 2 rolls for this application in the pic. He stated the install started out slow but after getting the right tools for the job (a straight edge blade such as an Exacto Knife, a metal straight edge and a small rolling pin) things went much faster and cuts looked much better. It appears to have adhered really well but only time will tell on that. We keep the boat in the garage so the material is not exposed to the elements except for when we take the boat on the water. I can attest to the material feeling great under foot and working great while fishing from the bow of the skiff. The color combo works really well for the look of the boat. Happy with this purchase. Will update as time goes by on this.