INCLAKEINCLAKE Car Backup Camera, Rear View Camera Ultra HD 12 LED Night Vision, Waterproof Reverse Camera 140° Wide View Angel with Multiple Mount Brackets for Universal Cars, SUV, Trucks, RV and More

Pretty good camera! I installed it myself on my 98' Toyota Camry. The photos you see there are me tube shrink soldering the reverse trigger wire from the Video Wire to the Reverse Input wire (purple on my radio's harness). I mounted it above the car's emblems. I sealed the camera cable with some Black RTV silicone adhesive. The instructions are NOT great for installation. Also, a TIP is if you want to trigger the camera when put the car in reverse you got to make of course make the same connection as I did in my photos. But, also with the power wire it the camera system brings you have to take the black and ground it to the harnesses ground wire (mine was white with a black line) and then take the red wire from the power wire and along with the Video Wire's red wire mate them TOGETHER to the reverse power wire (which is also red) on the car's reverse harness connector. This part was confusing for me because the power wire this system brings also comes with its own shorter thinner red wire and I didn't know where it went. But it's NOT needed for the installation. So, instead you just tape it away and proceed with the Video Wire's red thinner wire instead.

The camera works great.My application is different from most in that I wanted it mounted higher so that I could see over bikes on my bike rack. A camera mounted near the license plate would be blocked when bikes are loaded.I didn't want to drill a hole so I mounted the included bracket to a small black right angle bracket (from a hardware store), that I then mounted to a car roof magnet (purchased here on Amazon). I ran the wires through a gap in the minivan rear window hatch, so no holes were drilled and the camera can be moved if needed.I connected the reverse trigger wire to my backup light wire near the rear left taillight assembly. The included blue snap lock wire tap was too large for my backup light wire, so I used Posi-Tap connectors instead (purchased on Amazon). In the photos, I show them side-by-side. The wire easily pulled out of the blue connector. They fit snugly in the black Posi-Taps. If your backup light wire is thicker, the included blue tap may work for you.I installed the camera with the 'always-on' power option so I can view the video anytime while driving (not just while in reverse). I'm not using the on screen guides (cut the green wire) or the LED lights (cut the brown/orange wire). Instructions say there is a brown wire (my camera had an orange wire, not a brown one).Because I routed the camera wire a longer distance (to the side of the minivan window) than a standard install near the license plate. I needed to extend the wires. So I purchased a waterproof junction box (on Amazon) and connected the wires to the extensions inside that box. That's the small black box with green tips seen in the photo. That is NOT included or needed with a standard install.So far, I'm happy with the video quality.

Important bits first:LEDs stay on ALL THE TIME when powered, does not have a switch (or light sensor) to turn them off and leave camera on.Requires a VCC (red wire) switch, not a ground(black wire) switch. Presumably because the power and video signal share a common ground.Getting that out of the way, it has good picture quality for a backup camera and a wide view angle. From my experience I would not recommend mounting it low to the ground, probably better mounting it higher up and pointing it downward. Lesson learned, mount it in a real world setting (not your garage) and mark the holes when you are satisfied, then go home and make it permanent.Another "lesson learned", is to test the wiring beforehand. I found out after the fact that this camera in particular will continue to receive a ground connection through the video cable if the power cable ground is switched off. In order to turn off the camera it needs to lose the VCC (red wire) connection, so lesson learned..I give it 4 stars because overall, the only problem with the product is that the switch needs to be connected to VCC side of the camera rather than the expected ground side switch.

The media could not be loaded. Awesome camera for the price. Install was easy and image is very clear and crisp. I was reluctant to buy a higher price camera since I was installing on my 09 Honda Accord with built-in Navi that didn't have a backup cam. I wanted to make sure the Navi would support a backup camera so I went cheap. To my surprise this camera is so much more than I expected for the price. Longevity is yet to be seen, I only had it for a week.