Nigo Industrial Co. 3-Way Tee Brass Hose Fitting, 3/8" x 3/8" x 3/8" ID Hose Barb Pipe Fitting (Pack of 1)

I bought the 1/8" x 1/8" x 1/8" Barb.It is NOT.... 1/8" x 1/8" x 1/8".It is METRIC and DOES NOT FIT 1/8" black PVC tubing such as those used on swamp coolers and available at your local hardware store.More precisely:Standard 1/8" barb diameter is: .213" (close to 1/4")The barb diameter of these tees is: .158" (4mm)In other words, it will "almost" fall out just with gravity and certainly fall out of standard 1/8" tubing if shaken.Even more simply, it CANNOT WORK.It cannot be sold as 1/8" x 1/8" x 1/8" Barb without lying.Even a "loose fit" requires .165" to be sold as 1/8" x 1/8" x 1/8" Barb. (20 thousandths interference)So check the ID of the hose/tube you are going to use these with.If it is 1/8" (.125") these will Not work.The only good thing about them is that they are shiny and there is only 3 per bag.

One issue with the 2013-2019 Subaru is minor but a real pain to fix. That is the front wiper hose. The little plastic Y breaks into many small pieces, pollutes the lines and nozzels and makes the system inoperable. You have to take the cowel off to get to the nozzels and all the lines you need to pick the little plastic pieces out of. It is a real pain. Not hard but tedious. I replaced mine with a 3/16 brass T. Sun and heat will not cause it to fail. The dealer quoted me $400 to do the job for the $5 part which was just another plastic Y. Wow. Even though I had to buy three of these $10 and 1 hour time was all it took. Even though now I know how to do the job in much less time, the Brass T means I won't ever have to do it again. I couldn't find these at the local home hardware store and one cost the same from a plumbing supply place.

I used one of these to set up an outdoor shower. I hooked the fuel hose to all three sides, and attached other valves to make the whole thing work properly. I think there were 3 in the pack or maybe 5. I think you can buy different amounts, but the point is that the product is great and well worth the cost.

These look really nice upon first inspection, and really are well made. Unfortunately 2 out of 3 in each of two packages I got had pinholes in the casting on the bottom of the tee. Barely visible, but sure enough, it leaks. A little dot of JB weld takes care of it, but you shouldn't have to do that. If they get the casing fixed, these will be great little items.

The product was solid brass. Very strong for my application. Using it was a good choice.

These were impossible to find in a store so I had to order online. They fit a 1/4” air hose perfectly. The barbs are long and sharp enough that I haven’t had any problems with them slipping off.

As mentioned by another reviewer, 2 out of 3 in the package had a pinhole in the casting. Not good if you’re using for high pressure air applications. Can fix with JB Weld or something similar, but shouldn’t have to.

Clean machined finish. Good quality metal.

Solid brass T's, fit perfectly for beer gas distribution. No complaints!

Just what I needed for my # carbs, great quality.