Raspberry Pi Camera Cable, 15 Pin Ribbon Flat Cable, Pi Camera Flex Cable, Flex CSI Cable 15cm/30cm/50cm for Raspberry Pi 3B+, 3B, 2B (Not for Pi Zero) - 9 Pack

very great camera cable would definitely recommend buying it came in different lengths which was great

I had a slight issue with one of the cables in the pack (the one that was the perfect length for my project). Contacted the seller and they made it right. Dont hesitate to order these, the look far better than the white cables, install easily, and with the support from the seller, no worries if there are any issues.

These seem to work just fine. I put the 1M cable on my 3d printer between a pi and a camera. They are much thinner and feel more fragile than the cables you get from adafruit, etc. They remind me of camera film in thickness (if you're old enough to know what that's like)So far that's no problem but I'm betting they'll be easy to damage.

Used to install RPi camera on 3D printer, so could monitor print progress/issues through OctoPrint.Man these cables where coiled tightly.I picked the size I need, then had to coil it backwards, wrap with a rubber band and let it sit for two days. It still wants to coil back up.At least it kept them from becoming creased during shipping.

Being blunt and honest there isn't much to review, it's a camera cable for your raspberry pi and you either know what your doing or you don't, does the image quality look bad? Then it's probably because you didn't focus the camera. Pi doesn't see the camera? Probably because you didn't enable it in raspi-conf. It's a camera cable, they come in multiple sizes and they do there job.

I frequently tinker with Raspberry Pi and a touch screen display or camera. This cable allows me to NOT add bulk or need to allow additional spacing for the Pi as well.

For starters, this cable came coiled up so tight I had a lot of trouble getting it laid flat and run where I needed to. Then, when I hooked it up between my camera and Pi 3B+, the Pi couldn't detect the camera. I tried a different cable and everything worked fine. I went back to this cable, and upon trying to boot the Pi, it would no longer start. From what I can tell, the voltage regulator is now bad as my 3.3V rail is shorted to ground. The only thing I've changed recently on it was this cable, so I have trouble believing it is just a coincidence. Regardless, I am returning and would not recommend as now I not only need another cable, I also need a new Raspberry Pi.

Great product just what I needed to reach further for my Octoprint setup.Cables are fairly thin, Rolled up super tight. But work just fine.