A-Premium Pair (2) Front CV Axle Shaft Assembly Compatible with Jeep Wrangler 2007-2017, Wrangler JK 2018, with Dana 186 mm Axle, Driver and Passenger Side

It definitely fits on my 2007 Jeep Wrangler a little bigger knuckle and it's normal to get a little gear oil once you pull it out the old one

Exact fit for 2015 JK. No issues on installation - it was nice to have a grease fitting on the u-joint as well. Recommended.

I purchased a set of axle shaft assemblies for my 2013 Jeep Sahara. I had both professionally installed.the driver side almost immediately started leaking severely. I brought my vehicle back to the shop. After disassembly again it was found the shaft was a fraction larger than the original. It would not seat properly and caused the leak. I had to spend additional money and labor and purchase another axle. If you are considering buying from this company think hard. Fair warning given.

Replaced my 2007 Jeep jk drivers axle. This is a pretty solid axel. I’m not sure about the u joint but is a grease-able one so that’s a plus. Was in a pinch to get it on the road so I’ll probably replace u joint with a spicer at some point . Splines were well lubricated and slid right in. So far no issues. It is made in china label is on the carton it shipped in.

Axle was coated in a rust preventative solution and then sealed in a bag. Axle quality is good. I didn't have any clearance issues after assembled. CON 1. Axle nut contact points is beyond poor. Most of the bearing stress is near the points of the hex rather than on a bearing surface generally on a hex nut. Kit should include a washer or a properly designed axle nut.

Good

Good quality part. But... yes as what seems to be the case with all these axles is grinding is required. The CV is larger and the axle hits on the hub bolts. The vendors don't just make parts not to spec. Chrysler must have changed the print. I bet if you buy new hub bolts they have smaller flanges, pre ground, if you will. Wish I did. No biggie, got a bench grinder.

The axle was shipped and delivered very promptly, arriving well packaged and in perfect condition. My 2010 JKU Sahara with a Dana 30 (230,000 miles) was a bit of a pain to disassemble, but replacement of the the axle was straightforward and problem-free. The old u-joint was shot. Also replaced the wheel bearing and ball joints. The new axle's u-joint is significantly beefier but fit beautifully. Should be good for another 250k !!

Priced right for a quick replacement part…

Jeep wrangler jku, ça fit parfaitement et ça semble de tres bonne qualité !

Perfect fit. Nice to see a grease fitting on the u joint. Only thing I could ask for is the plastic shield to seall the axle end.

The part made it to me in great time and was exactly what I needed. Fit my 2007 Jeep Wrangler well and installed with no issues.

Works as Intended