3M Spray90 High Strength Adhesive, 500 ml

3M Spray90 High Strength Adhesive, 500 ml, Wow this thing sticks, bought due to the mirror on the wing of the car fell off. The mirror while it came off did fall on the grass so when i retrieved it, it was still in one piece. I clean both surfaces (back of the mirror and plastic backing that the mirror was once attached too before applying the adhesive. I went over both the mirror and panel three times then crimped it together and left for 4 hours. I honestly felt three sprays were too much and leaving for 4 hours was also too long because no sooner did i apply and stick together the adhesive was already going hard. Anyways it been over a week the mirror is still in place and the adhesive is still rock hard and the mirror doesn't move nor can i even try and part them. For that alone this was easy to apply, had great adhesive it harden well so happy to recommend this product. Value wise i felt the product was priced reasonable well, can be used in a wide variety of uses whether that's upholstery, trim, wood working, or insulation. Overall its a great quality product. I would say make sure you spray this outside as it does smell and quite strong. It does bond easily and quickly so be quick and make sure the items used are correctly inline otherwise your not prying them apart. The spray had good coverage but as the pieces were small if needed a larger coverage area then possibly the coverage a cost could be a little better. Would recommend.

Top quality product. Very, very effective. Easy to use.

I purchased this to re attach the glass that fell off my wing mirror on my Audi S5. After reading an online article on how to remove the heated back plate from the mirror assembly I cleaned both the plastic back plate and rear of the glass and used the adhesive as recommended. Remember this is contact adhesive so it needs to partially dry for a few minutes prior to mating the two parts together. For those removing heated back plated that the glass was attached to, be careful removing the spade connectors from the heater pad as being too rough can damage the heater pad itself. This is a fantastic adhesive and allows for thermal expansion differences between the plastic heated back plate and the glass. Do not use super glue or epoxy type adhesives as these do not allow for the difference in expansion between glass and plastic. This is a top product and has so many uses around the home and for DIY. It dries quickly and forms a very strong bond.

Worked well on a headliner. Slightly difficult to use on your own as it grabs instantly.

Easy to use, strong glue

Easy to apply and sticks really well But be aware its instant contact so make sure the parts are aligned before placing them together

Used it for a car headliner, it was okay, the spray was sometimes intermittent.

Only used this once so far but it did the job marvellously, sticking the glass of a wing mirror to the backing heater element.

Me ha ido perfecto para recolocar los adhesivos de la moto que se habían despegado.

Lässt sich sehr leicht auftragen und ist sparsamer als gedacht....

Utilisée pour coller un ciel de toit d'une ancienne DS, super top. L'embout est réglable pour diffuser le jet et c'est très pratique.

la colla e' valida , non e' molto rapida , ma va bene , ottimo l'ugello , regola l'ampiezza dello spray . davvero utile.

Extrem nützlich