12V Remote Switch

I would buy these again for other applications. The operating range is good. The adhesive on the magnetic mounting stickers is strong. The magnet strength is sufficient (not amazing). The only small things to consider is that there is an audible click when the unit turns off. Note the one mounting bracket position, suggesting it's implied to be mounted vertically (it may sag if mounting horizontally). It still operates at 4.25 volts. Anything below 4.25V may not be enough to power the switch. Lastly, there is a visible red light inside the unit when it's on.

I purchased this for the light above my bed in my camper. It was so annoying turning off the light when you were getting ready to go to bed because you couldn’t reach it. I added this in and now I have a switch when you enter the bedroom and one beside my bed. It seems to function well has a great range, easy to install and seems to be good quality. This is a nice addition for convenience. so far, I have not had any issues with the remotes and it has definitely been worth the money.

Used mine to control a relay that operated a solar well pump. Works from quite a distance. Would buy again.

Wiring is much simpler than others that has NO/NC where you have to jump out the terminals. Magnetic strength is pretty weak but works. Would buy again

Installed easily to my light. Installed one in RV kitchen with dual pendant lights and another in RV bedroom. Bedroom had only single manual switch at door entrance so adding remote allowed 2nd remote to be placed at the bed so can keep light on until in bed then turn off. And turn on when in bed to easily navigate out of bed. Kitchen light also needed remote switch since the only manual switch is awkwardly placed in the RV master control cabinet. Who wants to walk to a cabinet 15 ft away to turn on a light over the sink?? Bad RV design in my opinion. Newly installed remote switches are not placed on the sides of the island sink for easy on/off operation. Deducted 1-Star because of the poor magnetic mounting system of the remote switches. The metal disc included does not provide enough hold power for the remote's magnets. Confident the issue is with the metal plate since the remote magnets do a good job holding to the metal refrigerator. To fix the issue, I ended up installing with 2-sided sticky foam strips. Holds good now but will be an issue when I need to change batteries as this will require ripping off the strips to unscrew and replace remote batteries. Overall still a good product; just needs to improve the remote mounting system so the remotes don't slide off. Current magnets don't even do well sitting still in RV and will easily fall off going down the road.

These work very well for my application. They appear well made and a decent price. Easy to install and setup. The magnets are on the weak side but a small amount of silicone seal solved that issue for me.

Easy install and working like a champ.

Neat little rf control for a 12 volt light