Roberts 2057-1 1 Gallon Vinyl Composition Tile (VCT) Adhesive, for Installing Vinyl-Composition or Vinyl-Asphalt

I got this to reinforce peel and stick vinyl tile. I admit I was a bit cautious and didn't expect much from it due to low cost. I've ended up using expensive silicone based sealants on the past. That didn't last long though and left a mess on my wood underneath that was almost impossible to remove. This stuff did the job. I don't think I will ever have to worry about my tile coming up now. It dried quicker than expected and was easy to use. I got a old paint brush and a silicone spatula from the kitchen to apply it with. A little goes a long way is what I learned. Before I finished my project I realized I could use sparse amount and only only the edges to achieve the holding power I was looking for. Good quality stuff at an amazing price

This stuff is next-level sticky! I used this to re-stick some old peel and stick flooring that was coming up. I was able to re-stick the old tiles, and then I used this to add some extra adhesive on the new peel and stick vinyl planks that I was installing. They have not budged at all, and I've used it to add some extra sticking power to some peel and stick faux brick on the walls in our house. We're currently re-painting and modernizing our house, and this stuff has really helped to make our DIY updates more permanent. This stuff is dangerously sticking though. After doing the floors, my hands were sticky for days. I tried using rubbing alcohol and acetone to remove it from my hands, and this stuff would not budge.. I did some laundry and made the mistake of cleaning the lint trap, and I ended up with linty fingers for two days. I then tried using some simple black vinyl gloves that I'd had in the house and they got so sticky that I was struggling to move my fingers in them. From here on, I'll just deal with the sticky fingers for a few days, cause this stuff was worth it.

So far so good we’ll see long term effects. Not as bad to Handel as some others

Purchased to re-seal treading on stairs. Will need long set up time and warm temperatures to get adhesive to properly bond.

I am replacing the vinyl flooring in my bathroom. Due to past water damage, the floor is uneven with dips. I originally got this floor glue to level those dips off. The really bad dips did not level off perfectly and some of the peel and stick tiles we're popping up along the edges. I used some of this glue under the lifting areas and I have not had a problem since. Caution: this glue can get really messy and really sticky, so be super careful and wear gloves. A little goes a LONG way!!

What a sticky mess this stuff made. Seemed too thin to me, but what do I know. I'm not a floor guy. It took weeks to cure, and was difficult to clean off the surfaces of the tiles. the long cure time was mostly my fault, but it still seemed like it should not have taken so long.

easy to work with, did the job

This is some NEXT LEVEL STICKINESS! Perfect for wall, tile, linoleum, or vinyl (probably other stuff but I am experimenting). Use disposable sponge pain brushes. You must have PATIENCE! I read that it’s impossible to get off hands and floor and cleanup is terrible. NOT SO!!!!!! Have some Orange Glo furniture polish on hand. The PERFECT SOLVENT!!!!!! You can thank me later.

as described

Super bueno pude pegar elmpiso sin problema se debe dejar secar y luego quebseque se pone el piso

Súper buena resistencia y fácil de aplicar

Muy buen precio

Funciona muy bien