VIGRUE 20 Sets Waterproof Automotive Weatherpack Connector Kit with Terminals & Seals, 1/2/3/4/6 Pin Electrical Wire Connectors for Wire Harness Repair, Cars, Trucks, Motorcycles, Marine & RV

Excellent vendor and product make sure to follow the instructions carefully

Used these to make some circuits on a lawn tractor project. They were easy to use, and I was able to use my Metri-pack crimpers on them. Assembly and operation went well.

This is an excellent setup for rewiring that project that maybe needs a clean up or weatherproofing. I got this kit for a rewire job on my boat. It is a very versatile kit with a good mix of the various wire counts. Only complaint is related to the finished connectors... the pins need to be fiddled to get them centered well but this is typical of these less expensive kits from "overseas." Also, there were no instructions with the kit. The item listing does show the basics, but you will go through a few pieces figuring out the process. PRO TIP: Use the rubber insert backers to "adjust" the position of the pin to the center of the opening(both sides). Push a little further in on one side of the rubber insert to nudge the connecter tip one way or the other as you insert the rubber bit. Otherwise, this is a great kit for a basic, low cost, multi-pin connector setup. 8/10 recommend with only drawback the relative cost vs quality aspect. These will work just fine for most people. If you want pristine, fool proof connectors, spend a little more money for a higher quality kit. If you are not that picky or otherwise able to throw money around, these WILL DO just dandy!

Used on 5.3 swap work good

They worked equally if not the exact same as weather pack connectors

Good assortment of connectors.

These are well made and are similar to GM weather pack connectors. However the keyways are the opposite of the GM connectors. They can’t be used with them. If you are doing a rewire or new wiring I recommend using these. I needed them for a repair so it didn’t work.

I love the design of these and they are somewhat easy to install. One important thing that I messed up was I put the male terminal in a female plug and had to redo. I will only do it once. They are easy enough to remove, but I hated wasting the terminal. The rubber stoppers should be good at preventing moisture and they look professional. I am installing these on parts of my wiring harness for a 1977 FJ40 Toyota Land Cruiser