Kel-Tec 380Rb P32/P3At BLT Clip Bllh

Very sturdy clip. I was surprised at how easily it attaches to my Kel-Tec P3AT. This is a true left-handed belt clip, there is a right-handed belt clip sold by Kel-Tec as well. Makes for an easily concealed 380, the belt clip itself holds firm and leaves me with no worries when I am running around with it attached to my jeans.

This is a very nice clip-on for the Kel-Tec 3At. Good manufacturing gives a firm placement. I like how it can be clipped inside a cargo pocket and remain in place for easy grab... I would recommend caution when/how you choose to use it... also, removing that pin can be quite a pain. If you don't have the correct size punch, it may be a good idea to bring it to a smith to avoid damage to the 3At. Speedy delivery and a quality product! :o)

Item was exactly as described, installation was simple, and it fits perfectly. Shipping time was about average. The price was just a bit ridiculous since you can get the same piece for right-side installation for around $12.00.

I purchased this product to add to my KelTec .380 for concealed carrying. It comes in very handy and has a unique appeal to it, almost as if it is a pocket knife clip. It installed in seconds and was a great/exact fit for the pistol. I immediately put in my pocket for trial and it felt great. No longer do I have to just have my gun loose in my pockets! I also tried it on the other side of my waist on my belt and I got the same sense of satisfaction. I strongly recommend this clip for anyone wanting ease of access and minimal bulk to your pistol. It is a great addition and well worth the cost!!! Happy Shooting!!!

Pin that came with clip would not fit in p32, to big . I tapped out the pin in p32 no problem. New pin wouldn't go in. Old pin went right back in. Not worth sending back. My loss. Don't waste your money.

Awesome. Fits perfect!

I ordered the right side clip thinking that is what I wanted since I am right handed. Wrong, I have to get my hand between the pistol and my waistband or pocket. I then ordered the left hand to correct this issue, much better. The clip is well made and easy to install. The down side is the fit. It is a little sloppy and the movement ends up causing the metal clip to cut into the polymer frame which causes more movement and so on. I tried to tighten up the right side clip fit and ended up snapping off a piece. It is high tensile strength metal so adjusting it is near impossible. I would definitely buy a replacement if the need arose.

Worked fine on my Kel-tec p32 FOR THE LEFT SIDE ONLY. I have another clip on the RS as well. If you intend to use 2 clips at the same time, R&L; you will need to open slightly (drill out) the clip mounting hole on at least one side to accommodate the thickness of the pin. This not an issue using just one clip, left or right.