Integrated Sequential LED Tail Lights Clear Lens for 2006-2015 Yamaha FZ1

This product works flawlessly and cleaned up my bike's rear tail section. I got tired of having external blinkers and wanted some built into the tail light. Found this tail light and purchased it with low expectations. However, it surpassed the low expectations I had. Very easy to install, had the whole job done in under an hour. Just be sure you have factory front turn signals because if you have led ones like I did, then you will need a pair of load resistors so they don't flash rapidly.

I like the product once it was installed you can switch between different light sequences and I'm okay with the factory one that I didn't have to adjust it, it was a tight fit with the original black fascia that goes in between and the outside of the lens but it went together okay... It was kind of a pain in the butt to tear the back of the bike apart and install it the wires are short so be careful and don't cut anything off... good luck enjoy it :-)

Received the tail light from Amazon last week. Instructions are less than perfect, need to take lessons from Akrapovic.Connector attached was a large block 3 pin connector. The bike connector was small round 3 pin, just like turn signal connectors. If you don't mind cannibalize your old like, you're ready to go. That's what I did, removed the connector from the old like and attached it to the new light.The hole to access the selector, very hard to get to once installed. And a pair of needle nose and jeweler screw driver are needed to get the plug in after mounting.Once installed the light has functioned as stated. Very bright, much brighter than the stock light and more visible.

Fits my 2008 FZ1 perfectly. It plugs right into the factory brake and turn signals wires, no splicing necessary unless you want to connect other turn signals. The sequential turn signal didn’t work for me, only about half of it would work on each side, but the light is programmable so I just set it to a solid flash instead of sequential and it works great. It is very bright and seems to be high quality.

I tried a new flasher, different front blinkers, resistors, everything and it only makes it half way through the sequential flash. Still works, but not as advertised. The only reason it really doesn't bother me is that I rarely use my blinker, that it still does kinda work, and that I bought it for the multi flash super bright brake.

Received the unit a few days ago and was finally able to install it and I am blown away at how awesome this product is!It works flawlessly and is super bright! Installation was straight forward but I did have a hard time with figuring out how to disassemble the OEM unit but thats because I was a newb to the FZ1.

easy installation, the brake light wiring snaps right into the bike's. I tied this into the existing rear turn signals which took a bit of extra soldering to tie it all in, but all in all I like it, much brighter than the OEM lamp, and the integrated turn signal work perfect. Form and fit are perfect for my Fz1

My power supply was not in the box, however, when I contacted them they sent me a new one right away. I could not be happier with the style and brightness.