Dp16 PA14-1/2 Bore22 No. 1-8 Involute Gear Cutters+ 7/16 Inch 22mm R8 Shank Milling Arbor Gear Mill Cutter Holder Machine

Nicely packed, quickly shipped complete set of gear cutters. I didn’t care for the 22mm metric bore. Would have preferred 7/8 English bore to fit existing arbors. They look good and are well marked but I haven’t had an opportunity to use them yet. Time will tell.

Nice!

Cutter worked great but the R8 arbor was tight in the mill when I come to take it out so I would throw a bit of anti-seize on it before putting it in I have a power drawbar and had a heck of a time getting it to back off

Es lo que esperaba

Works for me

awsome

Just right

Cons:The gear cutters have the wrong profiles. Some fit the profile somewhat better than others, but ALL of them have terrible profiles for their tooth range. The worst in my set is cutter #2 (Z14-16). Attached is an image showing a microscope capture of the actual #2 cutter I received overlaid on top of the correct gear profile generated in CAD. You can see how terrible the profile is, leaving only a sliver of material for the OD of the gear. I can confirm this is the case, because I actually did a test run cutting gears with these cutters and the resulting gear was severely thin. All of the other cutters are almost just as bad; each have their own problems. Some don't cut the root deep enough, some are lopsided. BEWARE these cutters. The arbor is good, but the cutters are absolutely horrid.Pros:The spindle fits very well and has little (if any) runout.The cutters are sharp and cut well.