VINYL FROG Clear Transfer Tape Roll 30.5x305cm for Self Adhesive Vinyl Transfer Paper for Signs Stickers Decals Walls Doors Windows Application with Low Initial Tack

Perfect for using with Cricut when transferring things to card/paper as it is sticky enough to move but not too sticky that it ruins the card/paper.

If you are looking for a good vinyl transfer for Balloons "hooray" you have found it, this product has the perfect adhesion for it, neither too strong to damage the balloon nor too weak, it is in the perfect spot, it does not leave residue on your balloons and will You can reuse, without a doubt I would buy it again and I recommend it 100%.

Works for me and I'm using it to lift vinyl prints on siser printable vinyl that's been weeded and needs lifting of its carrier sheet. This mask leaves no residue when heated up and has just enough tack with burnishing to lift everything off. Siser mask is £2 for an A4 sheet and this does the same job at a fraction of the price also the roll is going to last me ages making more profit on the items I sell.Only dropped a star because it could be slightly tackier then it would be perfect so 9/10

I struggled to use this with vinyl from a brand that Rhys with cricket and I may have cussed a few times just trying do a simple transfer.

Excellent product. Adhesive works perfectly. Does exactly what it should. Very versatile. Highly recommend

I’ve been buying this products for the last few years as I do a lot of vinyl work on balloons. Unfortunately the material on the new roll has changed. It’s very hard and plasticy whereas is used to be soft and bendable. Not great how as it’s actually damaging the balloons.

Just in case you were thinking of this for laser masking, it doesn't work too well. The adhesion is strong when applied over sealed paper (for jigsaw) and it pulled off the topcoat and some paper too. It also shrinks a bit when the laser cuts it so didn't eliminate fume marks. Probably fine for vinyl though!

I wanted this to laser cut detail masks for electro etching metal. This was a speculative purchase and I am pleased to say performed perfectly. The material cuts clean with the laser and functioned well with defined edges for the masks when etching.I suspect the tack will wear out long before I get to the end of the roll as I only use small quantities.