CompactorSplashback/Memo Board for Kitchen Wall, Magnetized, Stainless Steel, Silver, Thickness 0.6mm, 50 x 90 cm, RAN6472, Chrome, L

After getting a new fridge I didn't want all my magnets and letters clogging it up so purchased this and put it on the side of the fridge housing. It looks great and does the job

Bought this to be used as a magnetic notice board. Fixing was done by drilling the 4 corners, drilling and plugging the wall then fixing with screws and chrome cover caps. Works well and performs as expected.

I've knocked off a star for this board because I had to use a mix of oil and baking soda to get the sticky labels off when it arrived (from the packaging).The board itself is really nice and shiny but a few warnings from experience:- Do not rely on sticky solutions or double sided velcro. Drill it into the wall otherwise you will get a nasty surprise like I did.- Don't drag magnets across the board as some will leave scratches (as I found after my littles ones decided to play with my magnets)- The board is a little bowed against the wall; I don't think it will sit flat unless you use double sided tape along all the edges and screws

Actual item okay, arrived no instructions. Sharp edges, dangerous to handle. Definitely needed securely fitting to wall. In my opinion this item needs to be looked at for safety reasons, I would not get that item again in how it was presented to me.

Nice product and fits perfectly. However it was damaged in a corner and mis-shaped. Unfortunately, the lightweight cardboard packaging didn't stop it from getting bashed about during delivery.

Wish I believed some of the other reviews which said it was buckled etc. You can see how wavy it is. I tried to flatten it out anyway, but that was in vain.I decided to fit it anyway because I don't need it to be 'perfect'. I'm using this in my office to stick notes etc to. The wavy edge is not just wavy, it's distorted, i.e. you push one part flat, another pops out. You can see the gaps at the side.It's been cut from a larger sheet and that's all, no other finishing.The blue protection film is way too hard to remove (set aside like a half day for that).It's far too expensive for a crude piece of sheet metal. I'm so disappointed in this. I have supported it just from the bottom, because I want a seamless installation. Perhaps later I'll drill and secure it after a while.All in all, regret making this purchase. For a splashback, there is no chance I'd fit this in the kitchen.

Bought these to use in a studio setting - beautiful smooth edges all the magnets stick with ease and as for value for money - you might find cheaper - but at this quality I doubt it - well worth the cost.The only negative is that I ordered 4 of them & each one came in a separate LARGE box which was ridiculous !!

One side of the sheet is cut poorly, buckled and rough with a shabby finish.