CAR REAR VIEW CAMERA FOR AUDI A3 S3 A4 S4 A6 A6L S6 A8 S8 RS4 RS6 Q7

Camera angles too low, cant see past 8inch behind the car.

Fits as expected with minimal modifications. My car is a 2003 Audi A4 1.8T FWD (B6) which was listed on the compatibility list. The only mod I had to implement was drilling a hole to large enough to pass through the power and video connector ends and splicing a wire or 2 then running it to the head unit. This does involve removing interior panels, however. Otherwise, this unit fit into the license plate light cover just fine. I'm not sure why people complained about anything and here's a few facts...1) This is an aftermarket unit. Don't expect exact plug and play.2) You will have to mod your car a little and put in some effort and work. Again, it's an aftermarket unit.3) The camera quality is decent. It's not 4K HDTV.The only issue I have with this, and this is just me being a prick, is that the angle of the camera points too much downward. It would be nice if the angle were adjustable or the housing for the camera point upward a few degrees in the next revision.Otherwise, this is a decent product which beats others because it fits the opening as intended so it looks really integrated into the car.

Can't beat the price! Gave it 4 stars not 5 because, it didn't fit in the opening all the way. Camera is not the best quality but at least it works, also like the other review said the camera does point to much downward. The positives about it, led light isn't to bright. Camera does work, does everything you need for a back up camera. Like I said can't beat the price! Installed this in a 2005 b6 Audi A4

it points right behind the car where you can only see a 5 gallon bucket ant nothing else other than that it works but just ant useful for any thing

install of the camera was easy. but the liscence plate light does not work. Contacted customer service and they were on no help. Camera is not adjustabel and in my vehicle it is aimed too low so you can't see very far behind the car. I had to make shims to adjust he camera view up to make usable.

This took me 2 hours of modification to fit to my 2002 Audi A4 (B6). I had to drill a large hole in the light housing which wasn't a big deal to me. However, the contact prongs were not wired inside the camera correctly so I had to swap the (+) and (-) wires going to the connector itself. This required me to disconnect the wiring harness leading to the connector after removing the hatch trim. Not happy that I had to rewire the harness itself because the product had it's wiring done wrong at the factory.

Factory finish. Installed pretty easy into the original plate light. You will have to drill about an inch hole in the plastic behind the plate light, but the camera is good, and looks like it came stock

Works well. Not an easy install on my Audi A4, Car has no hole to route wires. Had to drill one through license light panel which was a little tricky.