MOTOALL Nylon Front Fender Liner Trim Panel Bumper Shield Retainer Fastener Rivet Push-Type Clips for 8mm Hole Honda Acura 91512-SX0-003 (100pcs)

Clip head is slighty raised, by design, relative to the OEM 8mm fender liner clips, but it's not noticable unless you look into the wheel well and, even then, most people would never know or notice.Holding power seems strong.These also fit the plastic cowl at the base of the windshield; except the 2 far clips which are 10mm clips, not 8mm.So...100 clips for the price of 3 or 4 OEM Honda clips was a bargain.

So far these have been decent. Several of the base part of them have not been the greatest quality i.e. two of the three legs that mushroom out when the pin is pushed are stuck together with extra plastic still connecting them because of bad quality control or not the best manufacting process. But for the most part they've worked out so far. Idk about re-use or how they stand up over time but I'll update this review after some time has passed.

I work at a Honda body shop so I'm very familiar with these clips. Other have said that they install easily, but don't remove very easily without breaking. I guess they haven't worked on many Hondas. If you're doing a Honda wheel liner plan on replacing every clip from Honda. They're brittle and break almost every time. The OE clips are better quality and you don't have to assemble them like these ones, bit They're both going to break once removed. That's why you're buying these in the first place

These things are super inexpensive compared to the Honda clips, and the product quality matches. Molding flash is not well controlled, and if you don't break it apart before trying to install, you will break the clips on install. HOWEVER, they work just as well once installed! On the flip side, if exposed to any heat or dirt whatsoever, consider them single-use if you try to remove them.

These are no where near the quality of the Honda/Acura OEM clips. They don't even look the same. I had a hard time getting the clip to go into one of the three places I needed these and when I tried to remove it, the entire thing came out. You can forget about getting these out if you can get them to go in. Definitely try another aftermarket kind.

Fits honda fenders! But pushing the middle piece in is a little tighter than the OEM clips. Removal will most likely break them or bend your fender tabs so be careful. Hence the minus 1. Otherwise, good price.

I was hoping to reuse the ones on my fender liner for my 2015 mdx, but they are really soft and they either broke or deformed while taking them off. These for perfectly and they have a nice positive feel when clicking in. Would buy again if needed.

Finally found an 8mm small clip that don't come with flared barbs. These actually go in nicely hondas and is secure. I haven't tested it's reusability, but factory oem Honda 8mm clips will usually break.