Nilight LED Light BAR & LED Work Lights Dual Push Button Switch 12V ON Off Switches with Connector Wire Kit 1.54" x 0.83" Replacement for Toyota Tacoma Tundra 4Runner FJ Cruiser Hilux Fortuner

Looks great and works great , it fits well with the other OEM buttons

"Spot Lights" Lighted Switch for Ditch Lights. Perfect fit and function for my 2015 Toyota Tundra TRD 4x4. The option for "Ditch Lights" came out after my purchase. So far so good after two years. Note: For my purposes, I used "Wiring Method B" while using 3 out of 4 wires. The Nilight wiring harness kit that I had left over from previous projects only had 3 wires available for the switch. Wire #3 "Red 2: Lower Dash Light Positive" was NOT used. This way, everything functions fine, including the blue backlighting only when it is turned "On."

I bought this to replace the one that came with a wiring kit that was made specifically for my Tacoma, and then the switch didnt fit the dash. This fit perfect and I have had no issues with it. Would recommend for a 08 Tacoma.

So the switch works. The wiring clip it has is not based on the Toyota clips, and so if you are replacing a functional switch get ready for a serious headache. However, if you are simply putting in a switch to control a relay or an amplifier, it works just fine and is reasonable to install. I tapped into ground from my cigarette lighter, crimped two spade-male connectors on the battery and relay lines, plugged those spades into the existing Toyota switch harness, and I was in business. I'm not using the dash light function (the second red/relay line) because I dislike it, but I tested and it did work fine, too. Overall, I'd recommend this switch, or perhaps a slightly less expensive one with a similar design. If I need to swap this due to failure I may buy again, not entirely certain, but it may be worth it to avoid the headache of having to run a new / different connector.

Good switch it almost looks OEM it was easy to run trough and splice the cables

Fits Perfectly, easy to install and comes with everything you need. The blue back light matches the OE lights on Tacoma. I would Definitely recommend it.

This switch is a perfect fit for a 2012 Tacoma, reasonably priced, looks well made and durable. however, the switch works as intended but not as desired with only "one" set of instructions to make the connections.. Basically, the back light stays lit "all" the time by following the recommended instructions. It hints of a possible other method to make the connections but gives no details on how to keep the back light off until the switch is pressed to turn on lights. Using the recommended instruction drains the car battery slowly especially if you incorporate a second bar light switch that functions the same way. A second switch may be required on the battery wire to kill the power to the back light located on the upper part of the light switch. In short, the upper two lamp indications stays lit all the time while the bottom spot light indication remains off until switch is flipped to turn on the spot lights or bar light.

Oem Fit 👍

Exelente producto

Item was as described. I installed it on my 2023 Toyota Tacoma. This switch fit into the factory dash spare knock out and was used to connect LED interior strip lights. I recommend this product.

Looks great but the actual button doesn’t function (sticks). To be fair I have ordered a couple other switches and they work fine. It’s upsetting as I am in the middle of wiring my lights and was waiting on this switch to complete. Now I’ll have to finish it another day.

Funciona perfectamente

Fits perfectly for 3rd gen taco 🤙