300-116 Hi-Ram EFI Intake Manifold Aluminum 92mm bore Compatible with GM LS3 L76 L92 L99 Chevy 6.0L 6.2L V8 Engine

The media could not be loaded. So far it works amazingly for the price, installing was relatively easy, takes about the same work as a Holley or any other hi ram. I would HIGHLY suggest taking a porting bit or sandpaper and smoothing out whatever you can reach inside the manifold, the casting is very poor on the inside, it is super rough and some edges are extremely sharp. I smoothed the inside of mine out in an attempt to get better air flow, so far so good. Overall you get what you pay for, this is a decent product for the price, only complaint is the casting.

I have to give this one a low rating. This is the product only. NOT the seller. The hardware that comes with it will not withstand the 106 inch pounds it says to torque it to. At 80 to 90 inch pounds, the nut strips the stud. Every time! Very poor quality hardware. Also, it is an intake for LS engines, but it says will not fit most LS injectors. I was able to make brackets. However, the fuel rail on the driver's side sits too far forward and the cross over hits the alternator.

The media could not be loaded. Really nice product was a little skeptical about ordering but took the chance and it was worth it over all great quality

will need some cleaning, but looks nice

lots of casting flash inside beware. your gonna be buisy inside breaking it off and dressing it.