HitLights 12 Pack LED Connector 2 Pin 8mm Solderless LED Tape Lights Connector Transparent LED Strip Lights Connectors with Screwdriver Strip to Wire for 12V 24V Single Color LED Light Strips

These connectors are great. Used 16 in my kitchen LED strip solution and haven’t experienced any issues. Comes with a screw driver to fit the terminal posts. The led strips still push in after removing the backing tape which is nice and when fully tightened the terminals hold solid. I recommend using a larger electronics screw driver to get these properly tightened. I stuck the tiny screw driver through my finger when it slipped off, so I also recommend tightening against a solid surface rather than in your hand. Great product - ordered again.

These are a game changer. Make sure you lightly scrape off with a razor the copper on the led strip as there is a coating on it. These are very small, inconspicuous, and work great. Highly recommend! We use to just buy piles of strips as none of the available connectors worked as well as the factory soldered connection. This is a nice and small screw in block that works perfectly!

These worked fine for me. I happened to already own a set of small screwdrivers so I used one of those. I agree with other reviews that say the included screwdriver might be tough to use. I'm writing this review to give you one hint.... Pushing the 8mm COB light strip into the connector is difficult, as the light strip is sort of spongy and it wants to pop back out. What I found worked REALLY well was to find a nice, square edge that I could push the connector up against and shove the COB light strip into it while I tighten the screws. This allowed me to hold it firmly in place until the screws were tightened. In my case, I was putting the light strips above and below kitchen cabinets, so I used a carving board shoved up against the tile backsplash on my kitchen counter. See photo below.

These were hit or miss. Some screwed down great, some stripped right out. Wish they came with a screw driver that was bigger then 1in tall LOL. Ordered a real size terminal screwdriver off of here to make screwing the screws down easier.

Useless. Purchased both 8mm and 10mm versions. These couplers didn’t connect to the LED strip securely and the other side would not grip wires. The connections are supposed to be made by driving the metal closed using the small screws, but there wasn’t enough movement to closed down on the led strip or wires. It was quicker and easier to solder wires to the strips. Great idea, poorly implemented.

The fastening feature is a nice idea but I found that wires easily slip out with the set screw securely tightened. Additionally, the metal contacts on the led strip side were not able to make a reliable connection to the copper leads on the strip.

Good connector

Works very well for wire to strip connection.