DAYUAN 5pcs Professional Front End Service Tool Kit, Pitman Arm Puller, Ball Joint Separator Tie Rod Remover Tool

It worked without breaking. I even used a pipe on the breaker bar for more tourqe. It pulled the pitman arm off a1990 f350. I did used a lot of beakfree spray first. No heat needed. I thought it was going to break but the arm popped loose

Excelente Producto

Solid units! Worked perfect! I will say that there is a bit of casting marks that are sharp, but no biggie.

Worked great! Had a tie rod stuck in the stuck in the steering knuckle. I was able to remove it in less than a minute. I would definitely recommend.

Good Stuff

I tried to use the ball joint tool on my 1995 Chevy 1500 , at it's widest opening it would not fit the lower ball joint !it's a very flimsy set of tools . The price of the kit is great if you can actually use it.

Works great

The metal is kinda soft, does not fit the Camry 2022 lower ball joint, at least. I had to cut the metal to make a wider fork opening so I could insert it underneath the lower ball joint.Because I cut the fork wider, the fork is getting thinner, so this part got bent. But the upper part of this tool is bent too! why? The only reason is that the metal is too soft. I bought a similar tool from Harbor Freight later, a black one, which feels like the metal is stronger than this one. But I didn't try, since the Harbor Freight one is too small to use.I finally used a hammer + this bent separator tool, and took the joint off.