91360 Igniter Kit Replacement for Weber Spirit E/S 200 & 210 (2009-2012), Spirit E/S 310 & 320 (2007-2012), with 2 Push Buttons & Metal Spark Box, AAA Battery, Spark Generator for Weber Ignitor

Igniter works as it should

Works great. Easy to install. Good value. Basically a direct replacement for original Weber part but for much less.

tel que décris je suis très satisfaite

Pour le WebberPerformer, il suffit juste d’enlever le support métallique.

Perfect fit and works great. NO INSTRUCTIONS.....so just pay attention to how you remove the old one. 1. Twist counterclockwise the button you push down to use as the igniter. Then inside there is another little plastic screw that you also unscrew counterclockwise. 2. Pull the black and white wires out of the push button module. 3. Where the igniter box is inside the barbecue, if you look on the outside of the barbecue casing where that little igniter box is placed, there is a little, sheet metal tab that you need to bend down so that you can pull that little square box with the igniter out through the INSIDE of the barbecue. It's rusty, so don't worry about using force to remove it! It takes some yanking ! 4. Now you can install the new one. 5. Feed the new 2 wires through the 2 holes FROM THE INSIDE of the BBQ and make SURE the open side of the igniter box is open facing the burner. That way the spark and gas can connect/mix inside that little box. ***Note: the flat metal tab next to the white, round igniter, FITS THROUGH THE LARGEST ROUND HOLE ! Then, once the tab is through to the outside of the BBQ, take a long flat screwdriver or other object and bend the tab straight up. I used a hammer to tap on the screwdriver to bend the tab up. That is all that holds that little igniter box in place. 6. Push the main igniter module up through the hole on the BBQ shelf where the knobs are and screw on the plastic nut ring clockwise. It was a little tricky to get it to line up just right for me. 7. Then I connected the wires. Connect the white and black wire to the same black and white tabs on the module. 7. Install the AAA battery. I think with the + end facing DOWN. 8. Screw the new button cap on clockwise 9. HAPPY BBQing............