Engine Motor Mount Compatible with 2004-2008 Solara 2.4L 2002-2006 Camry 2.4L Auto Transmission, Replace OE A4203 A4204 A4207 A4211, Set of 4

It’s a motor mount installation - if you know what you’re doing and take your time, these are easy to install and fit perfectly. If you’re doing this on a 2004 Camry, these front mount - near the radiator - you’ll have to either purchase or thread a top bolt. This kit comes with some double sided bolts, they are too long on that mount. The bolt from Toyota is too long for the mount. It’s an easy fix if you know what you’re doing, but be aware that you’ll have to adapt on the front one

Due to winter rust, I needed to replace two front mounts but ended up replacing all 4. They all fit nicely and seemed to be high quality. One tricky part was getting the transmission bracket seated onto the new mount that bolts to the transmission (front passenger side). In hindsight, I would recommend you remove the transmission mount from the car with the bracket still attached. There is just (barely) enough room for you to do this after removing the 3, 14mm bolts from the transmission (see pic) and the 3 bottom bolts from the mount. Then you can take the bracket off, see how it is seated, and put the new one on. I couldn’t even hammer the bracket on the new mount but was able to seat it after aligning it perfectly and then use an impact wrench to drive it on. If you look at the old bracket, the size is right and it’s supposed to be snug. With the bracket in place, you can then install it with just enough room back into your engine and align it with your transmission. Anyone who claims their engine still rattles after installing these parts, likely messed this part of the install up (i.e. didn’t seat the bracket correctly onto this mount) or has another problem entirely. My car is super quiet with all 4 new mounts installed. Also, I snapped one of my old posts off my old rusted mount and was unable to get the nut off. If your old mounts are really bad, you may want to order some high grade (10.9 or 8.8) M12 – 1.25mm flange nuts, which will fit the threads on most of these parts. M12 is easy to find but not with a 1.25mm/fine thread. I went to three hardware stores and couldn’t find one with the flange head like is used. Great set of replacement mounts at a phenomenal price! Install is a bit tricky but that’s not the product, rather my shade tree status!

I mean. It's a piece of metal with some rubber bits. Kinda hard to eff up. But, did the job on a 04 camry with an ALL THE WAY borked original. Slid right in like a loser into my babymama

Lo único es que uno de los orificios quedó más pequeño de lo que debe estar pero muy bueno

They work

👍

I have a 2005 Toyota Corolla. Only 2 out of the 4 parts fit. The driver-side one didn’t line up with the bolt holes, and the rear one didn’t line up either. The rear mount is also too big and hits the rack and pinion. And some power steering lines The only way to make it fit would be to cut metal and modify it,I do not recommend this product.

Just what I expected: excellent quality recommended 100% high quality product

جودة غير مقبولة بعد التركيب يوجد اهتزاز بالماتور بسبب سوء جودة الكاوتش الداخلي للمنتج و سوء التصميم لم يقضي على الاهتزاز بالكامل بل يوجد اهتزاز خفيف يسبب ازعاج للسائق